How do I change the foot switch on my computer?
Click “Apply to Foot Switch”, wait for setting update confirmation. Disconnect the foot switch from the computer and reconnect it. Note: When the foot control is then reconnected to the computer it will be connected in the requested mode.
Which is the best tool for foot switch configuration?
Any combination of keyboard command can be assigned to each pedal, allowing the control of applications through hotkey shortcuts. You can also create setting templates for quick and easy configuration. This tool can be downloaded from https://www.opdsupport.com/downloads/software/utilities 1. Foot Switch
How does operating mode affect the foot switch?
The operating mode determines how the foot switch is recognised by the computer and the method in which the foot switch sends the pedal press and release events.
What to do if your foot switch is not connected?
If no foot switch is connected, the last used custom setting template is displayed. Alternatively the “Default Template” is displayed when a custom template is not available. Manual selection of setting templates is also possible using this drop down menu. It is possible to create, save and apply pedal configuration settings by using templates.
How to change the operating mode of the foot switch?
To change the operating mode follow the steps below: The foot switch must be plugged into the PC and with the foot switch configuration tool open select required mode from the Operating mode drop down (section 4). Click “Apply to Foot Switch”, wait for setting update confirmation. Disconnect the foot switch from the computer and reconnect it.
How to change foot switch settings in transcription module?
Plug in the foot switch into the PC and open the ODMS Transcription Module software. You can check to see if the foot switch is recognised in the software by an icon in the bottom right corner of the screen. Go to Tools > Options > Device. Select the model of foot switch you have from the drop down in the left.
What’s the best way to adjust the foot controls?
Tip: there are typically two pinch bolts holding clip-ons onto the fork leg – when tightening them, make sure to do them evenly, alternating with half-turns on each until they are both tight. Check torque specs and use a torque wrench if you can – pinch bolts are usually not torqued very hard.
Any combination of keyboard command can be assigned to each pedal, allowing the control of applications through hotkey shortcuts. You can also create setting templates for quick and easy configuration. This tool can be downloaded from https://www.opdsupport.com/downloads/software/utilities 1. Foot Switch