How do I get a replacement key for my Kawasaki mule?
How can I get a replacement key for my Kawasaki? Replacement keys are available through an authorized Kawasaki dealer by providing your model and the key code number.
Where is Kawasaki key code?
Typically, Kawasaki’s have their key code stamped into the ignition switch. Removal of the ignition switch is required in order to view the key code.
What should I do if my Kawasaki MULE wont start?
Let it pump a minute, then try to start the Mule. Also, make sure you are not trying to start with a low battery, that could be a life long effort. These require the battery be fully charged for the pump and relays to function properly. Do not jump start it from a running vehicle, or you will damage relays and the igniter and may never start.
How do you Prime a Kawasaki 3010 mule?
If you have a manual with a diagram, you can find the fuel pump relay and jump two of the wires together…then the pump runs when the key is on and will prime the system. Seems like its the bk/blu and blk wires.
Can you change gears on a Kawasaki MULE 610?
Before the engine starts, it can shift into all gears; but after running, I cannot change gear. At… I guess i have a pretty good ear! I’ve always adjusted small engine idles by ear….. but i finally decided to buy a tachometer… it came in the mail today so i tried it out on the mule. it’s the kind that wraps around the plug wire.
Why is my Kawasaki UTV SxS 610 not starting?
I have been having in intermittent problem with starting. The battery is good, no loose ground wires, or any other easily identified issues. But about 50% of the time when you turn the key, you can hear (and feel) the solenoid moving in the starter motor, but the motor itself fails to turn, so it does not start.
Why does my Kawasaki MULE 610 not start?
But about 50% of the time when you turn the key, you can hear (and feel) the solenoid moving in the starter motor, but the motor itself fails to turn, so it does not start. And then 5 minutes later you might be able to go back to it and turn the key and it will start right up. Or it won’t start at all.
How to troubleshoot a mule that will not start?
Everything was running fine put it up one night, went out the next morning was a little harder to start (normally fires right up said it kind of sputtered) road it around a little and then parked it went back later and it will not start turn over but will not start. So hear is what I have went through.
Is the ignition switch on my610 mule bad?
I think the ignition switch on my610 mule is bad, turn key just clicks, had starter tested, batt new, lites work. In Motorcycle questions?
I have been having in intermittent problem with starting. The battery is good, no loose ground wires, or any other easily identified issues. But about 50% of the time when you turn the key, you can hear (and feel) the solenoid moving in the starter motor, but the motor itself fails to turn, so it does not start.