What does F1 light mean on GSXR?
The “FI” fuel injection warning light usually comes on with many gixxers when the “SET Valve” is not working properly! Your bike will run just fine, but it’s just very annoying to see it while you’re riding!
How do you clear F1 code on GSXR 1000?
Fi codes can be reset by jumping the pins on the white service plug under the pillion seat. It is a white plug with grey foam on it, under pillion seat on right hand side (If you are sitting on it). Turn on ignition and then off, then on again.
What does F1 code mean on a motorcycle?
It means you have a problem with the fuel injection system if you can start the bike then take it to a Suzuki mechanic. If the F1 is full on i.e.not flashing then the bike will not start normally. You still have a fuel system problem but now you have to find a way of getting it to a Suzuki mechanic.
What temperature should a GSXR 1000 run at?
About 180-190 normally, fan comes on at 220. Owner’s manual says that everything is fine until about 248, when it is officially overheating.
How do I reset my F1 light?
Place the side stand down.
- Turn the ignition switch to “OFF.” Make sure the engine stop switch is turned to “run”
- Remove the dummy connector and short the.
- Turn the ignition switch to “ON.”
- Remove the special tool wire from the DLC.
- The MIL will light for approximately 5 seconds.
What is FI light on motorcycle?
The FI indicator light (LED) emits service code(s) to show. the problem(s) which the DFI system and ignition system. has at the moment of diagnosis. Self-diagnosis Procedures. ○When a problem occurs with the DFI system and ignition.
How hot should a GSXR 750 run?
A. 105 to 110 degrees is the normal range for the fan to cut in, so I doubt it’s overheating. To properly check that there is enough coolant in the bike you need to start with a cold engine.