What should the voltage be without the starter button?
Checked voltage on green wire. 12.56 volts without pressing starter button. Press button and no change, still 12.56 volts on green wire. Did you do anything with the handlebars?
What happens if you hit the starter button and nothing happens?
Battery good, lights , horn turn signal works. Fuel pump runs , hit starter and nothing, lights do not dim and no sound at all. All fuses O.K. starter relay maybe ? any advice ? 06 roadking by the way.
How to completely wire a push button start?
I fix cars, boat motors, and love to drink Beer!!! 2001 Bayliner Trophy project boat. ELECTRONICS and Wiring. NOT EASY EASY!! 1982 35HP Evinrude Water Pump Install. One step Closer!
What to do when you press the starter button on a V twin?
You can jumper a wire from your battery positive post or the battery post on your starter to your green wire solenoid connection to see if the starter activates (make sure your in neutral and the ignition is shut off). If it does starter is ok and suspect the bad relay.
What should I do if my starter switch is not working?
If your solenoid is a four wire solenoid, check both small wire terminals as one is ground and the other is power from the ignition switch. *If your solenoid is a three wire solenoid, make sure the solenoid body is not corroded where it bolts to the chassis of the mower as this is your ground path back to the battery.
Checked voltage on green wire. 12.56 volts without pressing starter button. Press button and no change, still 12.56 volts on green wire. Did you do anything with the handlebars?
How do you hook up a Powermaster starter?
You need to wire a diode into the yellow wire, you want the power to flow to the coil. It should look like this: The arrow is the path of the voltage, the line repersents the dam that stops voltage from coming back (a one way check valve) wire it so that voltage goes away from the starter.
Battery good, lights , horn turn signal works. Fuel pump runs , hit starter and nothing, lights do not dim and no sound at all. All fuses O.K. starter relay maybe ? any advice ? 06 roadking by the way.
Where is the starter button on a V-twin?
In the starting circuit you have ignition switch, run/stop switch, fuse, starter relay, solinoid and starter motor… Using a tester light you can see if you have battery voltage to the solinoid… Look for the green wire… Turn you ignition on and hit the start button, if the tester light comes on then your relay is ok…
What do I do if my start button is not working?
In the window that opens there is a tab labeled Navigation. This will allow you to change the option to powershell instead of a command prompt. Now you can right click the Start button and on the menu list select the admin powershell option! Once you’re done you can change it all back to the default!
What does the starter button do on a scooter?
Pressing the starter button completes a circuit between the battery and the spark plug and also a circuit between the battery and the compressor, and turning the ignition opens the fuel valve. You also need to make sure that the scooter has gas and that the battery isn’t drained, of course.
What happens when you push the start button on a Harley Davidson?
There’s a connector plugged into the top of the starter, green wire. Unplug the connector and probe it for B+ while pushing the start button. If it shows volts the start button is good. Then take a jumper wire from the battery positive terminal to that same connector plug on the starter, the starter should spin and engage the engine (crank over).