Why is my brake light not working on my Harley?
When the rear brake light does not activate, we tend to think it’s the bulb, and sometimes that is not the case. In this video, Bob walks us through how to test a Harley Brake Light Switch to make sure that’s not the issue.
How to test a Harley Davidson brake light switch?
Ok , so working out issues on this 1989 FLHTCU I fixed the brake lights , the wires in the left side panel had to be cleaned a soldered then they stopped working again. I did a repeat on the test light still had power to the wires at the switch on the rear.
Why is the brake light on my Badlands not working?
Oh and BTW this is a NEW brake light assembly and I know the bulb works because I hooked it up to a stand by battery for a quick second to make sure. The turns and run/brake light are on different circuits so the Badlands module shouldn’t affect the run/brake lights.
Is it dangerous to drive with brake lights not working?
Driving at night with either brake lights or tail lights not working is dangerous for you and other drivers on the road. It takes a long time to notice when the brake lights not working but tail lights are or vice versa. It is so because you won’t know what is happening in the backside while driving until someone points it out.
When the rear brake light does not activate, we tend to think it’s the bulb, and sometimes that is not the case. In this video, Bob walks us through how to test a Harley Brake Light Switch to make sure that’s not the issue.
Oh and BTW this is a NEW brake light assembly and I know the bulb works because I hooked it up to a stand by battery for a quick second to make sure. The turns and run/brake light are on different circuits so the Badlands module shouldn’t affect the run/brake lights.
Ok , so working out issues on this 1989 FLHTCU I fixed the brake lights , the wires in the left side panel had to be cleaned a soldered then they stopped working again. I did a repeat on the test light still had power to the wires at the switch on the rear.
Are there brake lights and turn signals that work?
Running lines and trailer brakes work, but brake lights and turn signals do not. No blown fuses that state they have anything to do with the trailer Category People & Blogs Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
Where is the hot wire for the brake light?
The brake light hot wire is typically the red/yellow wire from the brake light switch to the tail light. The power wire to the switch is typically orange/white. Models without a central tail light are slightly different. Figure 7. Rear lighting diagram; look for shorts from main harness.
How do you close the rear brake light?
End of dialog window. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. When you pump the rear brake pedal, the rear brake light should tell everyone behind you that you are stopping.
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
Why is my tail light not working on my Sportster?
You can’t post conmments that contain an email address. try starting with the bulb. brake light bulbs are dual fillament, meaning you have 2 bulbs in one basicly. if your brake side has blown then the tail light could still work.
Where is the brake light on a Harley Davidson?
The turns and run/brake light are on different circuits so the Badlands module shouldn’t affect the run/brake lights. Two switches control the brake light function, the front switch by the brake handle and the rear switch in the brake line below the trans. The rear running light is on the main light circuit.
Why are the rear lights on my car not working?
The causes for dysfunctional rear lights are: 1 Burnt bulbs 2 Blown out fuse 3 Damaged wiring 4 Electrical issues
What kind of tail brake light cover does a Harley Davidson use?
Chrome Tail brake light Cover For Harley softail Dyna Touring XL883 XL1200 light (Fits: Harley-Davidson) Only 1 left! Harley Davidson Kuryakyn? Chrome Sportster Louvered Tail Light Visor Cover 23 product ratings – Harley Davidson Kuryakyn? Chrome Sportster Louvered Tail Light Visor Cover
Are there brake lights on a 2003 Electra Glide?
New to the forums here with a question. I just bought a 2003 Electra Glide Standard. I noticed the brake light wasn’t working with either the foot pedal or the lever on the handlebar. The lights are on while running but do not get brighter when using the brakes. So far I: -jumped the 2 connectors that attach to the rear brake light switch.
New to the forums here with a question. I just bought a 2003 Electra Glide Standard. I noticed the brake light wasn’t working with either the foot pedal or the lever on the handlebar. The lights are on while running but do not get brighter when using the brakes. So far I: -jumped the 2 connectors that attach to the rear brake light switch.
Is there a brake light switch on a Goodridge?
Goodridge has a brake light switch that is the banjo bolt as well. 1989 ultra , tail lights work but no brake light. Would the same test work ? Hi Samuel. Testing to diagnose an inoperative brake light is typically the same for any year or model motorcycle.
Why does my brake light keep flickering on?
Nearly all cases of a brake light staying on or continuously flickering have been caused by a damaged or faulty brake light switch. The problem is usually found in the right handlebar switch housing where the front brake switch is located.
The problem is usually found in the right handlebar switch housing where the front brake switch is located. Actuation of the switch is accomplished by the interplay between the brake lever/master cylinder assembly and the light switch.
Can a rear brake light switch not work?
Click here to cancel reply. The rear brake light switch can also fail in the on position. On cruise control equipped models this means that cruise will not engage. Brake lights will also always be on. The always on might be noticable in in a lower voltmeter reading on models equipped with a volt meter.
Goodridge has a brake light switch that is the banjo bolt as well. 1989 ultra , tail lights work but no brake light. Would the same test work ? Hi Samuel. Testing to diagnose an inoperative brake light is typically the same for any year or model motorcycle.
Why does my Harley roadster not turn on?
Hello, our 2016 harley roadster wont turn on. We just replaced the engine and it’s all put back together but nothing will turn on any idea? We charged the battery it’s still works great, checked the fuses those are good too, everything is plugged in its right place.
What kind of brake lights do Harley Davidson use?
Only 8 left in stock – order soon. ROGUE RIDER INDUSTRIES – Rear Motorcycle LED Turn Signals With Bright Red LED Tail Lights – BLACK LABEL SPECIAL EDITION – Motorcycle LED – Red LED Lights -1157 LED Turn Signal for SigZ Harley Davidson . . . . . .
What are the turn signals on a Harley Davidson?
ROGUE RIDER INDUSTRIES – Rear Motorcycle LED Turn Signals With Bright Red LED Tail Lights – BLACK LABEL SPECIAL EDITION – Motorcycle LED – Red LED Lights -1157 LED Turn Signal for SigZ Harley Davidson . . . . .
What kind of light does a Harley Road Glide use?
. 3-1/4 Inch LED Turn Signal Kit Flat Smoke Lens 1157 Double Base Amber Front Turn Signal Bulbs + 1156 Single Connector Red Rear Turn Signal Lights Compatible with Harley Motorcycle Road Glide Road King . Only 4 left in stock – order soon.
How many Harley Davidson Bad Boys were made in 1995?
Production for 1995 was 3,367 total; 1,747 with blue stripes, 1,618 with red stripes, and two special order. This bike is in mostly original configuration, with original frame, engine, transmission, and tins.
What kind of bike was bad boy in 1995?
1995 Harley-Davidson FXSTSB Bad Boy springer, COLLECTOR’s item, this is one SUPER RARE bike – less than 1200 miles! She starts, runs, rides, and sounds excellent. Factory stock seat, lights, and paint; black with blue trim – like new condition, garage kept.
What kind of motor does a bad boy have?
1995 Harley Davidson Bad Boy for sale. This is a low production softail springer manufactured from 1995-1997. It is powered by the 80cubic inch, 1340cc Evolution v-twin motor. There were only 8,346 ever produced. Production for 1995 was 3,367 total; 1,747 with blue stripes, 1,618 with red stripes, and two special order.
What causes a Harley Davidson not to start?
Some other ideas: 1 Problem with security module or key FOB 2 Problem with clutch safety switch, or its wiring (if bike has it) 3 Bad relay (like you said)
What to do when your brake light stops working?
locate your brake light switch and disconect the leads. Run a jumper wire across then and see if the light comes on or use a test light to see if it has power to it. also listen for the relay to click like it does when the front brake switch enguages. If it comes on the just replace the diaphram switch.
Why is the brake light not working on my Harley?
The running light is controlled by the main light circuit and fuse. I would check the wiring harness inside the rear fender for damage. You can also disconnect the rear light harness under the seat and apply B+ to the light terminals to make sure the harness is good. If I jumper the rear switches the brake light doesn’t work at all.
How do you test a brake light on a motorcycle?
Hi Samuel. Testing to diagnose an inoperative brake light is typically the same for any year or model motorcycle. If, neither, the front or rear switches are triggering brake light, you may find an issue in your taillight harness. Start by using your test light and multimeter probe the taillight socket and the rear brake switch.