Why does my bike light flash when I turn it off?
The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection.
How to start a bike without a fob?
Here is how to use the code you jus entered to start your bike without the Fob present!! 1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window. 2. Enter the first digit of your PIN (a) by pressing the left turn signal switch (a) times.
What to do if your bike won’t start?
1) Place Bike in NEUTRAL. 2) Remove the fuse cover and locate the start Relay. It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
Is the factory security system on a Harley Davidson?
Does the bike have the factory security system. Do the flashes start to blink on/off when you try to start it. It the answer is “No” to both questions perform this test. 1) Place Bike in NEUTRAL. 2) Remove the fuse cover and locate the start Relay.
When do turn signals flash, bike won’t start?
Re: Turn signals flash, bike won’t start, no key fob with… If you turn signal flashing,then your security system is on. You will need the key fob for starting.,or change the Bat on Key Fob. You can’t post conmments that contain an email address.
Here is how to use the code you jus entered to start your bike without the Fob present!! 1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window. 2. Enter the first digit of your PIN (a) by pressing the left turn signal switch (a) times.
An expert who has achieved level 1. Re: Turn signals flash, bike won’t start, no key fob with… My 03 Road king wouldn’t start and the blinkers were flashing back and forth and the little red key light was flashing. I pressed the fob four times and the lights went out and the bike started.
How long does it take for a car security light to go out?
With the key still in the run position wait 10 minutes and the security light should blink and then go out. Turn the key off and wait 5 seconds. Repeat these steps for a total for 3, 10 minute cycles.
The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection.
Why does my Harley Davidson bike not start?
When I turn on the bike and put it in the run position, the fuel pump kicks on, but when I push the start switch the bike doesn’t even try to turn over. The battery is fully charged and the fuel pump turns on when I push the switch, but nothing else happens.
What to do when your bike won’t start?
Got out the multimeter, checked all the usual suspects for continuity and spec resistance; still no spark. Put everything back together after pulling the ignition cover to check the pulser and stator (which were in spec); Got Spark!