Why does my Spyder have a brake failure warning?
I was sitting at a light two days ago, and I let up on the brake to drift a little forward and when I stepped back down on it to stop, the pedal went down with almost no pressure, I let up and stepped down again, and it had full pressure…… and the warning light came on and I have ‘Brake Failure’ scrolling on the screen.
Why is my Spyder not in the garage?
Haven’t been on for a long, long time due to wife’s illness. So, Spyder has been neglected just sitting in the garage. Well, being her primary caregiver for the last few years has the Doctor demanding I go do something away from the house for a couple of days for my health.
Are there any recalls on the can Am Spyder Rs?
These issues include safety recalls for your Can-am SPYDER RS and complaints other owners have filed. What is Recall? A recall is when a product is removed from the market or a correction is made to the product because it is either defective or potentially harmful. What is Failure?
I was sitting at a light two days ago, and I let up on the brake to drift a little forward and when I stepped back down on it to stop, the pedal went down with almost no pressure, I let up and stepped down again, and it had full pressure…… and the warning light came on and I have ‘Brake Failure’ scrolling on the screen.
What causes a soft code on a Spyder?
Most of the time on the Spyders when this occurs its from the rear master cylinder reservoir, either the fluid lever drops and or there is a problem wit the sensor. If its just the fluid and you fill it back to the correct level then the warning should go away, that would be considered a “soft” code.
Haven’t been on for a long, long time due to wife’s illness. So, Spyder has been neglected just sitting in the garage. Well, being her primary caregiver for the last few years has the Doctor demanding I go do something away from the house for a couple of days for my health.
How to reset brake pedal on can Am Spyder?
The brake pedal traveled too far before there was enough pressure in the system. As you said you where afraid of. It is one of the few sticky faults that have to be reset. Turn the key on and wait until it fully boots up. Press down hard on the brake pedal and hold it. Turn the key off and wait until it completely shuts down.
Is there a recall on the Spyder RT?
The component is new for 2020 and the flaw was discovered during the assembly process. Dealers have been notified of this issue and the recall is expected to begin next month. Most owners won’t be able to ride them in the current pandemic lockdown, but they should be careful with the brakes and bring the RT in to be fixed.
Are there any problems with the can Am Spyder RT?
Below is a list of complaints & problems filed against the 2011 CAN-AM SPYDER RT. These problems includes information received by NHTSA from consumers either directly or as recorded by the Vehicle Safety Hotline. This information may be used by NHTSA during the investigation process.
Are there any problems with the Kaw Spyder?
As a result, the rider sets off unaware that there is total brake failure in one circuit – the rear. No-one has lived to report it in the front brake. I and a handful of other owners have reported this to federal vehicle safety authorities in Canberra but due to a loophole in the relevant ADR wording Kaw has got around it.
How to cancel brake failure message on 2012 RS SM5?
2012 RS sm5 With the Brake Failure Message on the screen. Press the Mode, Set and Turn Signal Cancel at the same. The code (s) will appear. Write them down and post here. We will point you in the right direction. With the Brake Failure Message on the screen. Press the Mode, Set and Turn Signal Cancel at the same.
When does the brake failure warning light go away?
It normally pops up after the bike has been ridden for a while and then stopped and then re-started (like a gas stop). It first occurred on the Blue Ridge Pkwy, after a scenic stop. Both brake reservoirs are topped off and the brakes work fine. The warning light will go away at some point, but sometimes it will stay on for hours.
Do you need to troubleshoot your car’s braking problem?
Seriously, brakes aren’t something to play around with. If your car is having a braking problem, whether it’s weak brakes, a mushy pedal, or grinding sounds, you need to troubleshoot and repair it as soon as possible. We’ll help you diagnose your braking problem, so you know what repairs to make.
What can I do about can Am Spyder recalls?
This is an online automotive information provider ✅ of a detailed information on complaints, defects and recalls for Can-am SPYDER RS. Our users can find data on mass market car models from most popular brands. The service allows to compare and analyze statistics for reported problems, complaints, recalls for various manufacturers.
The component is new for 2020 and the flaw was discovered during the assembly process. Dealers have been notified of this issue and the recall is expected to begin next month. Most owners won’t be able to ride them in the current pandemic lockdown, but they should be careful with the brakes and bring the RT in to be fixed.