What is the torque for harley primary cover?
Registered. Outer primary cover is 108-120 inch (9-10 ft.) lbs. Derby is 84-108 inch (7-9 ft.)
How much torque does a Harley Davidson 103 have?
Harley-Davidson PowerPak Features: The Twin Cam 103 is rated at 102 ft. lbs. of torque at 3500 rpm, a 9.6-percent increase in peak torque over the Twin Cam 96 engine it replaces, extra power for enhanced passing and hill-climbing performance when a passenger and luggage are on board.
What are torque settings for replacing primary and inspection covers?
I’m planing to change the primary oil and inspect the primary chain on my 1997 Dyna Low Rider. Can someone tell me what are the torque settings/specs for replacing the primary and inspection covers screws?
What causes a primary chain case to leak?
The primary chain case cover contains Harley primary chain case lubricant which lubricates the clutch pack and primary chain. Failure of the primary chain case cover gasket or either of the two inspection cover gaskets will result in a leak and need to be replaced. Start the motorcycle and drive it until it is up to operating temperature.
How much lubricant to put in a primary chain case on a Harley?
Install the jiffy stand and jiffy stand mounting bolts. Torque the bolts to 15 to 20 foot-pounds with a 3/8-inch torque wrench and Allen driver. Add 38 fluid ounces of Harley primary chain case lubricant to the primary through the clutch inspection hole.
What’s the sequence for the primary cover on a Harley?
I tighten my Primary Cover screws in the same pattern that I tighten lug nuts on a wheel with five studs. I also use blue locktite (service manual). Definitely don’t over torque. They have a tendency to like to stick and they’re a bitch to get out if they do. Sequence is 2, 7, 10, 5 and 12 o’clocks.
What are the torque specs for the primary cover?
Discussion in ‘ Softail Models ‘ started by Longhair, Apr 6, 2008 . Hi everyone, Can anyone tell me what the torque specs are for the primary cover. The book I have does not say anything about it.
What are the torque settings on an old Britt?
Steering head stem nut (tighten second, 1 nut, 0700101) 25 – 30 ft lb. Yoke pinch bolts (tighten third 2 bolts, 06-1911) 30 ft lb. Front fork pinch bolt (one bolt) 10 – 15 ft lb. Spindle nut (1 nut, 06-0361) 60 ft lb. Slider pinch bolt (1 bolt/nut, 06-2465) 15 ft lb. Fork damper tube anchor bolt (1 bolts) 10 ft lb.
How big are the screws for the timing cover?
Timing cover screws (see tightening order, 12 screws) 60 – 80 in lb. Chaincase Attachment Nut (one nut) 25 ft lb. Alternator mounting stud nuts (3 nuts) 15 ft lb. Chaincase fixing bolts (3 bolts, 06-2669) 60 – 80 in lb. MK3 Chaincase outer screws (10 screws, 06-5533) 60 – 80 in lb. MK3 Long starter screw (1 screw, 06-5532) 8 ft lb.
I tighten my Primary Cover screws in the same pattern that I tighten lug nuts on a wheel with five studs. I also use blue locktite (service manual). Definitely don’t over torque. They have a tendency to like to stick and they’re a bitch to get out if they do. Sequence is 2, 7, 10, 5 and 12 o’clocks.