What is a CDI trigger coil?
A Capacitor Discharge Ignition or CDI is an electronic ignition device that stores an electrical charge and then discharges it through an ignition coil in order to produce a powerful spark from the spark plugs in a petrol engine.
Where does the spark plug go on a stator?
-The two primary terminals on the ignition coil are shared by multiple components, and therefore will have two wires coming out of each. -The raised center terminal on the ignition coil feeds the power that goes to the spark plug. This is where the spark plug wire will connect.
Where is the stator in a CDI coil?
Follow them to where they connect to the CDI, coil, and rectifier (should be around the headlight area, under the plastic. Remove the pair of three wires in one connector (should be a green, a red, and a red/black). Check for ohms between each. If any show open, the stator is gone.
How is the pulser coil connected to the CDI?
From the stator: blue & green from the pulser coil to the CDI. The blue here is actually connected to the ground. The CDI’s ground wire is black/white; ( near the stator) single blue to the CDI. Good luck and thank you for asking FixYa. You can’t post conmments that contain an email address. An expert who has achieved level 1.
How does the new Rick’s stator plug in?
The new Rick’s stator leads eliminated that intermediate connector and plugs directly into the regulator via the extra length leads that came on the Rick’s stator. Great forethought on Rick’s part! The new Rick’s works wonderfully and much better than the original ever did. Rock solid performance. It fit right in, no mods needed.
-The two primary terminals on the ignition coil are shared by multiple components, and therefore will have two wires coming out of each. -The raised center terminal on the ignition coil feeds the power that goes to the spark plug. This is where the spark plug wire will connect.
What happens if you don’t have a stator coil?
The stator coil generates the power for the spark plug and other accessories on small engines Without a stator there would be no spark at all, meaning the engine won’t run. While a stator is dying, it can produce a weak spark, causing the engine to miss or run poorly. Symptoms are often worsened as the engine warms up.
How does a capacitor discharge ignition ( CDI ) system work?
Working principle a CDI System. A capacitor discharge ignition works by passing an electrical current over a capacitor. This type of ignition builds up a charge quickly. A CDI ignition starts by generating a charge and storing it up before sending it out to the spark plug in order to ignite the engine.
When to buy a new stator for your engine?
I devised this system when the stator on my Honda XR-100 got so weak that it couldn’t power the spark plug, preventing the engine from running. The stator on my model happened to be discontinued, and I didn’t want to buy a used one for over $100 when this particular stator is known for being weak and prone to failure.