Why are there 13 codes on the trx500?
The TRX500 uses 13 codes because of the (throttle position) TP sensor , and the TRX500FA & TRX400FA use different codes again.. Great post!!!
Are there different ESP codes for Honda TRX350?
Most of the time, its a wiring issue…a stick pulled a connector loose, or water got into a connector. Yes these are the ESP codes for the TRX350 & TRX450 The TRX500 uses 13 codes because of the (throttle position) TP sensor , and the TRX500FA & TRX400FA use different codes again..
How to troubleshoot an error code on a treadmill?
Turn the treadmill of by the on/off switch. Wait 30 seconds and turn the treadmill back on. 2. Wait for the embedded screen to completely reboot. If the error code 21 continues, check connections. Check Connections 1. Check the Translator Board (Fig. 1). Verify that some of the LED’s on the board are lit. a.
What is the error code for Star Trac fitness?
STAR TRAC FITNESS 1 of 2 637-1420 Rev: A Error Code: 6 Embedded Touch Screen Error Code 6 is reported when the FitCPU does not receive a query id from the Translator Board when the treadmill is powering up. Possible Causes: • Loose/disconnected communication cable between the FitCPU and Translator Board (treadmills only).
How do you find the problem code on a Honda trx500fa?
The problem code is displayed by a certain number of blinks “ – – “ on the gear indicator, which indicates the problem code by the number of blinks. If “N” (neutral) stays ON on the position indicator, the retrieval process was not correctly performed.
Are there different ESP codes for the TRX350?
Yes these are the ESP codes for the TRX350 & TRX450 The TRX500 uses 13 codes because of the (throttle position) TP sensor , and the TRX500FA & TRX400FA use different codes again.. Great post!!! I did the test on mine and no flashing!! what,if any,is the procedure for a 2000 450 es ??? (as far as the electronic shift goes)thanx…..
How many times does the Honda shift indicator flash?
You should see “ – – “ for approximately 3 seconds then off, then the “ – – “ should flash, once for code one, twice for code two and so on. The engine control module (ECM) can store two different codes. If your ECM has stored two different codes, the first code displayed is the most recent and the second code is the earlier code.
What’s the error code for Honda Foreman 500?
2012 Foreman 500 with an error code of 2 long blinks followed by 2 short blinks. can you point me in the directions of problem? My 2018 Honda Rancher ATV Has the check engine light blink 3 long and 2 fast , can anyone please help? 2007 Honda Rancher FM 420- blinks 4 long and 1 quick in the FI section of dashboard.