Can you pull start a Kawasaki mule?
Pull starting is pretty much limited to small displacement and low compression engines such as those used in lawnmowers and other power equipment. Even motorcycle engines of moderate displacement can be hard to kick start. And that’s using your full body weight and the far more powerful muscles in your legs.
Why does my Kawasaki MULE 610 not start?
But about 50% of the time when you turn the key, you can hear (and feel) the solenoid moving in the starter motor, but the motor itself fails to turn, so it does not start. And then 5 minutes later you might be able to go back to it and turn the key and it will start right up. Or it won’t start at all.
Are there any problems with the mule 610?
Those are a couple random thoughts on this situation, for what they’re worth. @007 Mule 610. It will start and run for about a minute the dies. It blow 20 amp fuse. I am having this issue right now.
Where do you fill the crankcase on a Kawasaki MULE?
In most cases, filling the crankcase until it’s ONLY between the checkered markings on the stick is sufficient. It doesn’t always need to be at the top line-which is the “high” mark. The bottom line is the “low” mark. In between is perfectly acceptable.
What did I do to my kawaskai mule?
I replaced solenoid, battery, cleaned all wire terminals only worked when battery was fully charged until I added the relay.
What’s the problem with my Kawasaki MULE 610?
My Kawasaki Mule 610 2007 misses and dies if not pressing the accelerator. New carburator, new air filter, new gas filter, changed oil & filter and still have the same problem. Suggestions pls. Did you find the recommended reading relevant to this discussion?
What are the specs of a 2007 Kawasaki MULE?
Below is the information on the 2007 Kawasaki Mule™ 610 4×4. If you would like to get a quote on a new 2007 Kawasaki Mule™ 610 4×4 use our Build Your Own tool, or Compare this UTV to other Utility UTVs. To view more specifications, visit our Detailed Specifications.
What causes a kawaskai mule to not start?
Click to expand… A defective Bendix or Starter Clutch as it is sometimes called could cause these systems. When you turn the key, the solenoid could energize and the starter motor could try to turn but if the Bendix is frozen it will not start . . .click-click-click!
How to troubleshoot a mule that will not start?
Everything was running fine put it up one night, went out the next morning was a little harder to start (normally fires right up said it kind of sputtered) road it around a little and then parked it went back later and it will not start turn over but will not start. So hear is what I have went through.