How do Harleys charge their batteries?
The charging system consists of three main components: the battery, alternator, and the regulator/rectifier. Your motorcycle battery stores electrical energy for use and acts as a buffer for the bike’s electrical system. The alternator creates alternating currents to run the bike and charge the battery.
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
Why does my Harley Davidson not have power?
I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection. Charge the battery on a good bench charger, not a Tender, but a real charger. Remove and reconnect both battery cables making sure they are tight and connections are clean.
Can a battery be cranked at 12.8 volts?
Yes, I have done the free power mod. voltage doesn’t tell you anything. only a load test will tell you if it’s any good. it doesn’t pass the test for the load your starter is putting on it. +1 what Eddie said. If you have a fully charged battery and it drops below 9V while cranking it is toast. 12.8V is not good for a fully charged battery either.
How to change the battery on a Harley Davidson?
Click…Click…Click is never a good sound when starting your bike, especially on a beautiful day to go ride. Not to worry, I am here to help ya with changing your battery out. What you’ll need is some patience and tools: New Battery (of course), take your old one to an auto parts store and exchange it for a new one, about $80ish. Loading…
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
What should the voltage be on a Harley Davidson Dyna Glide?
Use a voltmeter to measure the available voltage at the battery. A battery that is 100% charged will have approximately 12.6 volts, whereas a battery with a 0% charge will read 11.8 volts or lower. If your battery is low, charge the battery on a setting no higher than five amps for a few hours.
I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection. Charge the battery on a good bench charger, not a Tender, but a real charger. Remove and reconnect both battery cables making sure they are tight and connections are clean.
Why is my Harley Davidson Dyna Glide not starting?
If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.