What causes a Harley Davidson not to start?

Some other ideas: 1 Problem with security module or key FOB 2 Problem with clutch safety switch, or its wiring (if bike has it) 3 Bad relay (like you said)

What should I do if my motorcycle won’t start?

If the reading stays steady, your battery is good to go—and your motorcycle likely has another problem (or a few problems). Fortunately, there are other troubleshooting means that can help determine why your bike won’t start.

What’s the voltage on a Harley Davidson starter?

I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.

Why does my motorcycle not start with the side stand down?

Newer bikes (and some older ones) may refuse to start with the side stand down. Along with all the other high-tech sensors that are on board, your motorcycle might have a built-in code that keeps the ignition from starting if your kickstand is engaged.

Why does my Harley Davidson bike not start?

If you can start the bike this way; the start switch is probably bad, or a wire may be damaged. Let us know what you find. Sounds like you know what you are doing. You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start.

Why do you need a pin to start a Harley Davidson?

Keeping an active fob on the bike means you have no factory security (as far as theft protection goes) AND when the FOB battery dies YOU will be locked out of being able to start YOUR bike if you don’t have a PIN and know how to use it. The CHOICE is YOURS, and yours alone. In the owners manual is the procedure to use the pin to start.

What to do if you get an error code on your Harley Davidson?

Turn OFF the ignition switch. Run your bike and shut it down then recheck the DTCs again by repeating steps 1 to 9. If the code is current it will reappear. Press and release the odometer reset button to continue to the next module. Turn Ignition switch to OFF.

Why does my starter click when trying to start?

The starter will either push the jack shaft out and spin (then the starter is good )or the jackshaft will click in and out rapidly and then you’ll know it’s the solenoid hold in coil. But it’s probably just the battery. Was this answer helpful?

What to do if your Harley Davidson won’t start?

Harley Davidson Won’t Start But Cranks HELP! – YouTube Harley Davidson Won’t Start But Cranks HELP! If playback doesn’t begin shortly, try restarting your device.

What did the battery light come on on my Harley Davidson?

Rode about 70 miles yesterday. Everything was fine as usual. Stopped for gas. She fired right up. As soon as we hit the road the battery and engine light came on. Pulled into the next gas station and shut her down. Waited a few minutes and she started right back up but lights still on. Headed home.

Why is my motorcycle not starting after years?

If you still can’t get the motorcycle to start after going through this list, there may be a few underlying issues especially if the motorcycle was sitting for a few years. It’s actually pretty common for water to get inside the engine and rust the pistons into place. It’s annoying when this happens, but it is fixable.

What can cause a 1983 Harley Davidson Sportster to not fire?

You can’t post conmments that contain an email address. I have 1983 Harley Sportster 1000 that won’t fire when I first turn the key, but after a few minutes it fires right up what can cause this? Harley Davidson XLH Sportster…

What do you need to start a Harley Davidson?

The bike has to have a signal from the key fob before it will allow the bike to start. The TSSM is the – turn signal security module ( Japan & Korean markets only) I asked the dealer is they could test the ECM and they said yes if it on the bike.

How to get a long-stored Harley running again?

“IMO – 1st change the oil and filter as described above. Put a new AGM battery in it, drain the old gas by removing the rubber hose on the front of the tanks tank to tank. Refill with new gas and turn the key on. Listen for the fuel pump to start and stop, turn key off, and repeat. This time crank it up and let her idle a while.

Is it time to start a new Harley Davidson?

But despite what you might think, it’s not a good idea to jump on your dusty ride and immediately try to crank it up. This is especially true of any Harley that’s been sitting for more than a few months. A few years? You’ll want to do a little preventative maintenance first.

What should I do if my Harley Bike wont start?

“Has the engine been started or the crank turned since you took possession of the bike?” asks 2013 FLHTK. “Might want to remove the plugs, spray some fluid (Marvel Mystery Oil), place the bike in fourth gear, and move the rear wheel manually.” “Ain’t that complicated,” adds Notgrownup.

Why does my Harley Davidson make a hard clicking sound?

Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing. Is this a bad battery?

Where does the charge lead go on a Harley Davidson?

The battery charge lead runs form the voltage regulator to the positive side of the battery. The AC output lead wire leads from the voltage regulator to the stator.

Why does my 1999 Road King not start?

I haveA 1999 road king have not rode it in about three years ,gas tank had treatment ,has been started and ran fine however tried to start, will start with choke on. Sprayed carburetor with carb cleaner still starts only on choke ,goes off when choke is taken off. I appreciate the post for valuable information.

Where is the start relay on a Harley Davidson?

It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.

Why is my Harley Davidson Dyna Glide not starting?

If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.

How to start a Harley Davidson that wont start?

Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL. 7) Turn on ignition ON and Kill switch to run. When you touch both of your installed wires together DOES bike crank./start? Click to expand…

Why is my Harley Davidson Road King not starting?

If you have a Tachometer, disconnect it. A bad tach can interrupt proper coil function. i have problem error code U1301 in Harley Davidson Road King 2009 and test everything not starts . I have a 92 FXRSP, I recently replaced my switches and I had a new battery.

What causes a Harley Davidson to not turn over?

If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.

What are the most common problems with a Harley Davidson?

Fuel System Failures Vapor lock malfunctions, fuel injectors, and defective pressure gauges are among the most reported problems with a Harley’s fuel system. These problems can be costly and difficult to repair. Complete regular maintenance checks on the fuel system to guarantee that it’s running properly. 6. Accessories

Are there any problems with the Harley Davidson clutch?

This recall involved problems with the clutch system which won’t fully disengage. In the report, Harley-Davidson said this is the result of gas bubbles in the master cylinder clutch. If you’re considering these models, check with the dealer to make sure that the clutch got flushed or the master cylinder got rebuilt.

Is there a recall on the Harley Davidson Road King?

In 2015, another recall issued by Harley-Davidson targeted its classic Road King model and other models from 2014 and 2015. This recall involved problems with the clutch system which won’t fully disengage. In the report, Harley-Davidson said this is the result of gas bubbles in the master cylinder clutch.

Are there any problems with the new Harley Davidson?

This is one Harley to avoid. Yes, it’s a new bike, but the Livewire has had numerous problems in its short on again off again life. The electric bike has experienced problems with its charging system, which in turn led Harley to stop production of the bike in October of 2019.

How often does a Harley Davidson engine fail?

This metal-to-metal contact promotes engine failures which can be dangerous to you and your bike. This problem can occur anywhere from 15,000 to 75,000 miles depending on the severity. The only way to truly avoid this problem is to completely swap out the chain system for a gear-driven system.

Why is the fuel pump not working on my Harley?

Key fob battery was dead. Discovered that with a good battery in the fob when I turn ignition to on I can hear the fuel pump charging the system. When the fob is out of range everything works except the fuel pump. Hence the no start issue. Thank you a thousand times over. I spent Over two hours checking every electrical item I could.

Is it hard to start a Harley Davidson?

Hard starting when hot! New to Harley world, been riding metrics. Recently bought ’07 Ultra, rode to D.C. this weekend. Found that when bike is hot, doesn’t want to start. It doesn’t stall when hot, but if I shut it off it doesn’t want to restart.

Why does my Harley Davidson not start when hot?

Found that when bike is hot, doesn’t want to start. It doesn’t stall when hot, but if I shut it off it doesn’t want to restart. So far, if I sit there and hit the start button enough it will finally fire, but concerned that one day it won’t start.

Why is my starter not working on my Harley?

That black wire with the red tracer should be sending 12v to the starter relay. Be sure that this wire is not damaged or pinched anywhere in its travel. This will be more common when wires have been routed through the bars, or switch housings/switches have been changed. Don’t forget to use your multimeter inside the switch housings too.

What kind of EFI does a 2000 fltrsei have?

I have a 2000 FLTRSEI that had MM EFI. I got tired of cold start/idle issues that I could not fix. My bike is a different case. Being a factory screaming eagle the program that was flashed to the computer was unique to the FLTRSEI. If I reflashed and ever wanted to go back to stock I would have had to buy anothe ECM fromHD with the FLTRSEI flash.

What causes a Mercedes Benz to not start?

In most cases you will get a fault code related to one of the following: 1 ECM / PCM computer failure 2 Camshaft position sensor 3 Shifter Selector module 4 Fault codes related to driver authorization or immobilizer 5 Electrical problems

Some other ideas: 1 Problem with security module or key FOB 2 Problem with clutch safety switch, or its wiring (if bike has it) 3 Bad relay (like you said)

Can you start a Harley Davidson HD without a fob?

Starting your HD without a Fob! Your HD has the ability to be started without a Fob present jus in case the Fob is lost or the battery goes dead! Your Pin# to over-ride the security system is usually loaded up with the last 5 numbers of your Harley’s serial # backwards! (EX: serial # last 5 is 1 2 3 4 5……….it was entered as 5 4 3 2 1).

Why does my bike keep clicking the start button?

Took the battery to local auto parts store and checked out just fine with good charge. Put battery back in and hit start same click sound. After repeatedly clicking the start button I tracked the sound to the starter relay. Well with one hand moving the relay around and one pushing the start button bike would start up.

What does no start, no fuel pump mean?

Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good. Any other ideas? No start, no spark, no fuel pump. working on my 2008 screaming eagle ultra classic that I just got. Engine is a no start.

Why does my Harley Davidson crank but not start?

There have been a few reports of a P1009 code – incorrect password also. It appears the turn signal and stalls or cranks but will not start. Try removing the ecm and security fuses, wait ten minutes and reinstall the fuses. This “reboots” the turn signal module and the motorcycle will then start from that point on.

Why is my Harley Davidson Ultra Classic not starting?

I have a 2010 ultra classic with ABS. It is not starting. The battery voltage is 12.75 off the battery. When I turn the main switch on, I get a drop to 12.5, and when the kill switch is turned on, I get a drop to 12.38. The self test goes out and hit the start switch with nothing – no volt drop, no starter engage, no nothing. DEAD.

What to do if your Dyna bike won’t start?

Apparently, starter issues are quite common on various Dyna models, so if yours is in need of replacement, see How to Replace Starter. If you are in a bind and your starter motor is acting up, a quick tap of the solenoid with a hammer or similar small object can sometimes free the starter to start the bike.

Navigation