How do you start a Harley without a key fob?
STARTING YOUR HARLEY-DAVIDSON WITHOUT YOUR FOB! Immediately hold both turn signal indicators until FIVE dashes appear in the odometer gauge. Select the first digit of your PIN (a) by pressing the left turn signal button (a) times. Press the right turn signal switch one time to move to the next digit.
What do you need to start a Harley Davidson?
The bike has to have a signal from the key fob before it will allow the bike to start. The TSSM is the – turn signal security module ( Japan & Korean markets only) I asked the dealer is they could test the ECM and they said yes if it on the bike.
What to do if your Harley Davidson won’t start?
Harley Davidson Sportster: Why Won’t My Bike Start? 1 Test your starter. Refer to Step 4 of the article Electrical Diagnostic Guide for information on starter testing. 2 Check for fuel. If your bike cranks but doesn’t start, the first thing to check is the fuel supply. 3 Check for spark. …
Do you need to replace the starter on a Harley?
You can hear the solenoid activate and pop out, but the starter motor just spins. In our experience this is clearly a starter clutch issue and it will need to be replaced. The good news is you don’t need an entire new starter. Don’t waste your money and trailer your Harley to a dealership or mechanic for repair.
What’s the voltage on a Harley Davidson starter?
I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.
Is it time to start a new Harley Davidson?
But despite what you might think, it’s not a good idea to jump on your dusty ride and immediately try to crank it up. This is especially true of any Harley that’s been sitting for more than a few months. A few years? You’ll want to do a little preventative maintenance first.
What should I do if my Harley Bike wont start?
“Has the engine been started or the crank turned since you took possession of the bike?” asks 2013 FLHTK. “Might want to remove the plugs, spray some fluid (Marvel Mystery Oil), place the bike in fourth gear, and move the rear wheel manually.” “Ain’t that complicated,” adds Notgrownup.
How to prepare for a Harley Davidson ride?
Look at the subtleties and richness of the chrome, or lack thereof, and special features unique to the design of the particular Harley you are going to ride. Prep the bike for ride by checking the gas level, tires, lights, and any obvious flaws or defects. Get on the bike. Remember, “right is wrong.”.
How do you install a turn signal on a Harley Davidson?
Point turn signal straight ahead then tighten ball stud clamp securely to hold lamp in place. Route wiring from kit to connector locations and cut wires to length. Following applicable instructions from Service Manual, install terminals to wires and install to connectors.