What do I need to change my handlebars?
Changing your bars is also a great opportunity to check your handlebars and stem out for damage. All you’ll need is a set of allen keys, a tape measure and some electrical tape. If you have one, use a torque wrench. Once you’ve changed your handlebars, there are a few more things that you’ll need to do to finish the job. These videos should help:
How do I Turn Off the PassLock security light?
1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine. If it starts and run, the system has reset.
How long does it take for security light to turn off?
Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops
How to turn on security light without starting engine?
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
What happens when you turn on your security lights?
When you turn on the power to your security lights system, the motion sensors are activated and once they warm up, they can detect heat and movements in the surrounding area creating a “protective grid”. A movement sensor is tripped when too many grid zones are blocked by moving objects consequently changing the infrared energy levels.
How to troubleshoot outdoor security lights with Hunker?
Adjust the brightness and motion sensitivity to your area. The higher the light, the larger the coverage area, so try to find a solid place for the light to be securely placed high above the action but not too high that it won’t detect motion.
What happens when the PassLock sensor is replaced?
If the PASSLOCK (TM) sensor was replaced the SECURITY indicator will flash for the 10 minutes duration. If the EVO/PASSLOCK (TM) module was replaced, the SECURITY indicator will flash for a few seconds and then remain ON for the remainder of the 10 minutes duration.
How do you set up a smart security light?
If the app displays multiple devices, the one you’re setting up should have the strongest Bluetooth signal. Make sure you’re standing close to it. Once you have identified the closest Smart Security Light, tap that device’s name to continue the setup process. If there is only one device in the area, then you can choose that one.