Why is my hazard light not working on my Harley?
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
How do you put LED lights on a Harley Davidson?
Putting LED lights on a Harley Davidson usually requires that you install a load equalizer on the line. A load equalizer brings the load to the same level as two incandescent bulbs, so the system thinks that everything is okay. Check for a bad bulb: check all the bulbs for any burnt ends and replace them.
What does the Check Engine light mean on a Harley Davidson?
Check Engine Light. When the check engine light comes on, it indicates that something is happening or, in some cases, not happening. The easiest way to handle this is to do a “code check.”. The code will indicate what problem you’re facing.
Why are my turn signals not flashing on my Harley Davidson?
If you are stuck with having to manually cancel the turn signals, the problem could be found in connectivity to the speedometer or the TSSM. Check the switches. Check for loose or disconnected wires to the speedometer. Check the tip switch that cancels if the bike falls over.
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
What to do if your headlight is not working on your Harley?
Make sure your connections can be secure and are without corrosion. While your nacelle is open, try to get a look at your passing lamp switch and it’s harness. If you do not see anything obvious, plug your headlight in while it hangs loose. Turn on your ignition switch and tug on the related wiring harness.
If you are stuck with having to manually cancel the turn signals, the problem could be found in connectivity to the speedometer or the TSSM. Check the switches. Check for loose or disconnected wires to the speedometer. Check the tip switch that cancels if the bike falls over.
Where does the flasher go on a Harley Davidson?
Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad.
Make sure your connections can be secure and are without corrosion. While your nacelle is open, try to get a look at your passing lamp switch and it’s harness. If you do not see anything obvious, plug your headlight in while it hangs loose. Turn on your ignition switch and tug on the related wiring harness.