How do you test a crankshaft position sensor on a motorcycle?
How to Test a Harley Crank Position Sensor
- Turn the key in the ignition to the “Off” position. Turn the “Run/Stop” switch to “Run.” Push and hold the odometer “Reset” button. Hold the “Reset” button and do not release it yet.
- Turn the key to “Ignition,” but don’t start the engine. Release the odometer “Reset” button.
What to do if crankshaft position sensor fails?
Connect the CKP sensor electrical connector (3). If everything looks good, you need to check for an RPM signal or crankshaft position sensor signal. You will need a live data scanner to do that. See if the parts store will lend or rent one to you. If you find there is no crank signal, I would replace the sensor which may have failed.
Can a bad crankshaft sensor cause a check engine light?
Another issue of a potential problem with the crankshaft position sensor is an illuminated Check Engine Light. If the computer detects a problem with the crankshaft position sensor’s signal, it will activate the Check Engine Light to alert the driver of the problem. A Check Engine Light can also be set off by a wide variety of other issues.
What happens when the crank sensor on a Harley goes bad?
In newer models, the crank position sensor is designed in such a way that it allows you to reach your destination even after it goes bad. Usually, the symptoms of a bad crank position sensor on Harley Davidson are quite easy to notice. For example, you experience slight hesitation with the engine or reduced mileage, etc.
What should the rpm reading be on a crankshaft sensor?
If the scanner gives a reading between 100 and 500 RPM, then it is working fine. Anything besides that reading indicates a problem with the crankshaft sensor whereas, zero reading suggests that the sensor has failed completely. If you don’t have access to a diagnostic scan tool, you can also test the sensor using a multimeter.
What happens if the crankshaft sensor does not work?
If the crankshaft position sensor fails, it will not send information about the position of the crankshaft and speed of the engine RPMs to the ECU. As a result, the ECU doesn’t know when to send the spark plugs and how to adjust the fuel mixture. This can cause your car to stall or hesitate to start.
What does the crank position sensor on a Harley Davidson do?
It measures the rotation speed (RPMs) and the precise position of the engine crankshaft. The crankshaft speed and position are important for use in engine management circulations. Without it, the engine wouldn’t even start!
Where is the crankshaft position sensor located on a car?
Your vehicle’s crankshaft position sensor is located near the bottom of the engine by the crankshaft. That makes sense because it’s the crankshaft position sensor’s job to measure the crankshaft location. When you’re trying to track down the crankshaft position sensor, look towards the engine’s bottom, generally on one of the sides.
How to change the crankshaft position on a Mercedes Benz?
Unplug the electrical connector from the CPS sensor. Squeeze the connector and pull it away from the CPS sensor. This opens in a new window. Remove bolt. Remove the crankshaft position sensor. You will have either an E8 or E10 bolt that holds the CPS sensor in place.