Why does my Honda VTX 1300 not start?
Check to ensure the carburetor is not flooded and the throttle valve is open. Check the settings if the bike has difficulty starting. If the engine starts but then stops, the problem may result from improper use of the choke, a wrongly adjusted carburetor, low quality gasoline or a faulty ICM.
Why does my car not start after a jump?
When your starter stops working, it can’t “crank” the engine to get it started. Clicking or grinding sounds are clues that your starter might be the reason your car won’t start after a jump.
What to do if your car battery won’t jump?
During the cold winter months especially, it’s not uncommon to find yourself with a car that won’t start. All you need are jumper cables and another vehicle to get it going again, right? Well, not always. Many times, if your car won’t accept a jump, the issue lies with your battery — mainly that you need a replacement.
Why is the battery on my JumpStart not working?
It will not last forever. At some point, usually between the three-year and five-year mark from new, your battery will wear out and need replacing. Another possible cause is a defective cell or a short circuit within the battery.
Check to ensure the carburetor is not flooded and the throttle valve is open. Check the settings if the bike has difficulty starting. If the engine starts but then stops, the problem may result from improper use of the choke, a wrongly adjusted carburetor, low quality gasoline or a faulty ICM.
Why does my Honda lawn mower not start?
When you pull the starter rope, tabs extending from the pulley and cam should grab the hub on the engine, causing the engine to turn. When you release the rope, the tabs should retract and the rope should rewind back on the pulley. If the recoil starter assembly is not working properly, replace it.
What to do if your Briggs Stratton engine wont start?
If the start switch is difficult to turn or works intermittently, replace it. To determine if the start switch is defective, use a multimeter to test it for continuity. The switch should have an open …contact in the ‘on’ position and a closed contact in the ‘off’ position.
What makes a Honda VTX 1800 a Fi bike?
Now that has worked for Honda and many other manufacturers for years, the problem that sets the VTX 1800 apart is that it is fuel injected (FI for short). FI means this bike has a lot of electronics and sensors that carbureted bikes don’t have. Electronics need a good power source and good grounds to function.
How to fix ground bolt on Honda VTX 1800?
With the bolt removed, use sandpaper or a grinding stone (if you can fit it in there) to clean the powder coat off the frame underneath where the bolt sits. With the powder coat cleaned, use sandpaper on the ground eyelet and get it clean and shiny.
Where is the ignition coil on a Honda VTX 1800?
Look on the left side of the backbone towards the front of the bike – just behind the handlebars, under the front tank mount and in front of the radiator cap and you should see the front ignition coil. If for any reason you have trouble finding it just follow the spark plug wires from the front cylinder up, they plug into this coil.
Why does my 1989 Evinrude 150 XP not idle?
1989 Evinrude 150 xp with muff on it idles ok a little sneezing. In the water it doesn’t want to idle when in gear . From idle to plane the boat will bog down unless I choke it once it planes it runs great. I have rebuilt the 3 carbs and made sure each passage was not restricted.
Why does my car not run with the choke on?
Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.