How do I find my Harley Davidson code?
To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTC’s the code will be displayed or the word “none” will appear if there are no DTC’s. Push the odometer reset button again to view additional codes if they exist. 1 – Record the codes.
What to do if you get an error code on your Harley Davidson?
Turn OFF the ignition switch. Run your bike and shut it down then recheck the DTCs again by repeating steps 1 to 9. If the code is current it will reappear. Press and release the odometer reset button to continue to the next module. Turn Ignition switch to OFF.
How do I get the DTC code on my Harley Davidson?
To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTCs the code will be displayed or the word “none” will appear if there are no DTCs.
Can you reset the cel code on a Harley Davidson?
You may think you need an expensive code scanner or computer to check and reset CEL codes on your Harley, but the Motor Company designed a diagnostic mode into the computer. All you need are your ignition keys and a finger, and a pen to write down the stored codes before resetting.
How do you reset the odometer on a Harley?
To move from one letter (module) to the next, you push the odometer reset button one time. (from P to S to SP to t and back to P, etc.) To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release.
Turn OFF the ignition switch. Run your bike and shut it down then recheck the DTCs again by repeating steps 1 to 9. If the code is current it will reappear. Press and release the odometer reset button to continue to the next module. Turn Ignition switch to OFF.
To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTCs the code will be displayed or the word “none” will appear if there are no DTCs.
To move from one letter (module) to the next, you push the odometer reset button one time. (from P to S to SP to t and back to P, etc.) To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release.
What to do if there is no trouble code on your odometer?
If there are any DTC’s the code will be displayed, otherwise the word “none” will appear if there are no trouble codes. Push the odometer reset button again to view additional codes if they exist. Record each code and reference the list below. If DTC’s are not to be cleared, Press and release the odometer reset button.