Why does my Honda rancher 350 es stop shifting?

I have same machine same issue it will randomly quit shifting when riding I can cut off switch off and cut it back on shifts fine 2000 rancher 350 es any body have any irradiation trying to get this thing ready for my daughter for xmas Did you find the recommended reading relevant to this discussion?

How does the reverse shift switch on a Honda rancher work?

Your dealer told you wrong. The reverse shift switch detects whether or not the reverse lockout has been disengaged by pushing in the red button and pulling the lever.

Where is the angle sensor on a Honda rancher?

The angle sensor connector is at the sensor and the shift motor connector runs up on the frame. Just look around in the area the stick was (or could have been) and see if you can find any damage.

What to do if your shift sensor wont work?

Thanks TooDeep and Rich, you guys really helped me pinpoint the problem! I pulled off the cover to the shift angle sensor. The angle sensor was cracked in half! I put the pieces back together, put some electrical tape along the outside, and plugged it back in. I tested the shifter before bolting it back in… it worked!

Can a manual shift work on a Honda rancher?

The manual shift works though. I’ve had problems with the reverse sensor wire falling off the connector in the past. When I bought the ATV, the rubber boot was missing and the wire was just held on with a metal clip. I used pliers to tighten it on and it has stayed on.

Why is my shift button not working on my Honda?

You can hear the shift motor trying to make the shift when you press a shift button <->, but no shift occurs and, at times, you receive a – – – display. The problem occurs even more often when it is cold outside. Fortunately, the answer/fix to the problem is really very easy!

Is there a problem with Honda es shift?

Unfortunately, there has been one problem with ES shifting that has affected many ES owners at one time or another: The problem is that, at times, when you make a shift (up or down) on an ES machine, the shift is not complete.

The angle sensor connector is at the sensor and the shift motor connector runs up on the frame. Just look around in the area the stick was (or could have been) and see if you can find any damage.

How to fix Honda ATV electric shift issues?

Here’s your fix. Stop selling your Hondas cheap and take a few minutes to watch this & I’ll explain what you need to buy to fix the ES non shifting issues. TPS or Angle sensor or low battery voltage. End of story. Google how to replace these items. Good luck fellow riders. Loading…

Can a Honda rancher 350 go from neutral to first gear?

First was the idle, it was high as you suggested. Was around 1650, now is around 1400 which is the spec. Now will not creep at all in gear, can go from neutral to first or reverse without the brake on and it does not lurch or creep.

Why is my Honda TRX 350 es not shifting?

When I repaired my friends Honda TRX 350 ES Rancher, it was a broken leveling sensor located at the base of the engine in the front. It was broken in half and so it was not sending a signal to the ECU. So the ECU wouldn’t let the electric shift operate. When I replaced the leveling sensor, the electric shift worked great.

Is there a way to shift an electric rancher?

Is the Honda foot shift electric or manual?

Many of us have Electric Shift (ES) models. In fact, Honda sells approximately EIGHT times as many ES models for every foot-shift model sold. The ES models are very reliable. But, because of the number of ES machines that are sold and owned, it sometimes seems that there are more difficulties with ES shifting than with manual shifting.

What kind of car is a 2001 Honda rancher?

Ok, it’s a 2001 Honda Rancher TRX350FE. It’s the Electronic shift model. I bought it a few months ago, after only a few weeks we noticed that it would get stuck in gear after you’ve been riding it for a while. You would have to turn off the key and back on and it would shift again, for a while.

What to do if your Honda rancher 420 is not shifting?

Take the emergency shifter located under the seat on the 420. While the atv is still running, manually shift it back in to neutral and shut it off. It should be reset once you turn it back on and re start. Thats how mine was until i replaced the sensor. Be sure to use dielectric grease on the sensor plug.

Is it possible to shift a rancher manually?

Which means you can shift it electrically because it is equipped with shift up and shift down switches which energize a motor to shift the transmission for you. The back up to this system is a manual mechanical shift. If you can shift your Rancher manually, then there is nothing wrong with the transmission internally.

Why does my Honda ATV not shift at all?

If the atv will not shift at all, neither by the electric shift buttons or with the emergency shifter then it could be a bent shift fork or the shift reduction gear. The shift reduction gear can loose teeth in random spots around the radius of the gear causing shifting problems.

Why does my 96 Honda rancher not shift?

TheJ20jeepster troubleshoots the infamous 96 Honda Rancher electric shifter problem. Not the angle sensor this time so I go step by step through likely problems and find the culprit. Link to gear: http://www.ebay.com/itm/Honda-24615-H… Link to angle sensor video:

What to do if your Honda rancher 420 is not shifting?

Why is my Honda ATV not shifting properly?

Fortunately, the answer/fix to the problem is really very easy! The problem is caused by very heavy, stiff, gummy grease that was installed in the shift motor gears at the factory. Once that grease is removed and replaced with a different grease, you’ll be back to shifting normally!

How to check electric shift on Honda ATV?

Could save you a couple bucks on an angle sensor or a couple hundred taking it to the shop. First check your plugs make sure there’s no dirt or water in them get some electrical grease to help stop the water from getting in. Check your battery it also could give you problems.

Why does my Honda foreman not shift gears?

:confused I have a 2004 Honda Foreman that wont shift gears. The Gear selector indicator flashes 5 times and that indicates a ECM motor driver circuit. The 4 wheel drive selector also has stoped working. I have put power direct to the electric shift motor but it appears dead.

Why does my quad not shift into reverse?

The gear position switch detects what gear the quad is in, not the reverse shift switch. Your reverse shift switch is bad or there’s a broken wire/bad connection at the connector where it plugs into the reverse switch.

Is it hard to shift a Honda rancher?

When cold for the first 5 minutes it is near impossible to shift out of 1st gear. It will go into and out of reverse and 1st gear cold no problem. So I think ALL Honda’s are like this until you get 100+ hours on it. It’s a bummer something new is like that but unless you get the ES or Auto you have to deal.

Is the 2020 rancher footshift hard to shift?

I got a 2020 rancher footshift back In March I’ve got 300km on it and it’s also very hard to shift till it’s warmed up. Sometimes backing out of my garage I have to shit it off to get it in to neutral just to get it out of reverse. Dealer said this was a break in period. It is getting easier the more I break it in.

How does a reverse shift switch work on a car?

The reverse shift switch detects whether or not the reverse lockout has been disengaged by pushing in the red button and pulling the lever. If it doesn’t detect that you’ve pushed the red button and pulled the lever to actuate the reverse lockout lever, then it won’t let the shift motor shift the transmission into the reverse gear.

Is there a reverse switch on a Honda Accord?

Recleaned and disconnected and reconnected still no reverse. I am told by dealer that the switch in the rear of the motor is only for identifing when the machine is in reverse, not to shift it into reverse.

Can a Honda shift kit be used on a different model?

Every Honda ES Shift Kit is designed and built for each individual models and years. DO Not attempt to use the same kit on a different model due to the wiring harness lay out is different from model to model and even years of the same model can be different.

Your dealer told you wrong. The reverse shift switch detects whether or not the reverse lockout has been disengaged by pushing in the red button and pulling the lever.

Is the reverse switch on a Honda ES ATV working?

Check to see if the reverse switch is functioning properly. If not working, replace the reverse switch on a Honda ES ATV by watching the following video. Loading…

Why does my Honda ATV not shift gears?

ATVs with an electric shifter, like the Honda AS models, uses an electric motor to shift through the gears. If the motor does not work, the bike will not shift gears. The only way to make it shift is by using the emergency shifter (a short-shifting shaft sticking out the left lower side of the engine, use the supplied gear change tool).

Which is better manual shift or electric shift?

… Many of us have Electric Shift (ES) models. In fact, Honda sells approximately EIGHT times as many ES models for every foot-shift model sold. The ES models are very reliable. But, because of the number of ES machines that are sold and owned, it sometimes seems that there are more difficulties with ES shifting than with manual shifting.

Is the shift button on a Honda rancher good?

We used an ohm meter to test the shifting buttons and the angle sensor (just below the shifting motor on the front of the engine). The angle sensor reads good in its two positions, all wiring seems good, the shift buttons are good.

Is the Honda rancher trx350fe shifting problems?

The problem has progressively gotten worse where now you can only ride for a minute or two until it stops shifting. Of course, turning off the key while your in 3rd or 4th gear requires you to then rock the quad while pressing the downshift button to get it back down to neutral so you can start it again.

How to connect Honda ES Electric Shift Kit?

Connect the 2 shift kit large grey matching plugs inline with it. YOU MUST REMOVE the connector from the frame clip to unplug it. They can be very difficult to unplug clean all dirt away from retainer clip and sealing edges always pull on the plug not the wires.

How to fix electronic shift on Honda ATV?

The easiest way to get to it is if you have a winch. If you do, pull your atv into the garage. Connect your winch cable to an overhead rafter, and pull the front end of your Rancher up so that the atv is standing on it’s rear wheels. Good luck, it’s an easy (yet, very effective) project. Avery, Please don’t use google.

What to do if your Honda ATV won’t shift?

While the atv is still running, manually shift it back in to neutral and shut it off. It should be reset once you turn it back on and re start. Thats how mine was until i replaced the sensor. Be sure to use dielectric grease on the sensor plug.

What happens when you bypass manual shift on Honda es?

Everything on the dash will work as before showing correct speed and gear position* 4wd, and all temp, oil, neutral, and reverse lights but the gear position indicator will flash warning the operator it is in bypass manual electric shift mode. If playback doesn’t begin shortly, try restarting your device.

Navigation