Can Am Commander check codes?

Can Am Commander check codes?

Only dealer can pull inactive codes.

1. turn key to lights on position.
2. use mode button and scroll to engine hour (EH) on gauge.
3. press and HOLD the mode button while quickly toggling between high and low beam ( min 3 toggles in 2 seconds)
4. If there is any P-CODES they will be displayed.

How to check engine light on can Am Commander?

TSB# 2014-7, high altitude ECM re-flash. Takes less than 15 minutes, and my dealer didn’t even take it off my trailer or charge me for it. To read the p-codes, set key in lights on position, go to engine hours on the display, hold mode button and quickly toggle high/low beam.

When does check engine light come on on ATV?

I went out to Top Trails two weekends ago. Halfway through the ride my check engine light came on but never went into limp home mode. I cut my atv off and turn right back on and it would go off then 10 minutes later come back on.

Why does the Check Engine light come on after 13 miles?

After riding 13 miles at a 104 degree temperature light comes on and limp mode is displayed on the dash. Let it sit for an hour, start it up light comes on for a second goes off and that was it never came on again. Has any found a way to read these codes yet?

Where can I get a check engine light?

Hey K10 silverado, we offer a standard kit for the machine in your signature, or a kit that lays down a fair bit more and tilts forward like the XMR machine does with its factory kit. Thanks Rubberdown, i will definitely be ordering a kit from y’all soon. im trying to think of a good design to throw on it.

TSB# 2014-7, high altitude ECM re-flash. Takes less than 15 minutes, and my dealer didn’t even take it off my trailer or charge me for it. To read the p-codes, set key in lights on position, go to engine hours on the display, hold mode button and quickly toggle high/low beam.

After riding 13 miles at a 104 degree temperature light comes on and limp mode is displayed on the dash. Let it sit for an hour, start it up light comes on for a second goes off and that was it never came on again. Has any found a way to read these codes yet?

I went out to Top Trails two weekends ago. Halfway through the ride my check engine light came on but never went into limp home mode. I cut my atv off and turn right back on and it would go off then 10 minutes later come back on.

Hey K10 silverado, we offer a standard kit for the machine in your signature, or a kit that lays down a fair bit more and tilts forward like the XMR machine does with its factory kit. Thanks Rubberdown, i will definitely be ordering a kit from y’all soon. im trying to think of a good design to throw on it.