How do you adjust the clutch on a 2006 GSXR 1000?

How do you adjust the clutch on a 2006 GSXR 1000?

Major adjustment

1. Turn in the adjuster 1 all the way.
2. Remove the cap from the right side engine cover.
3. Hold the clutch push piece 2 and loosen the lock nut 3.
4. Hold the clutch push piece 2 And turn in the adjuster 4 until it stops.
5. Hold the clutch push piece 2 And tighten the lock nut 3.

How do you adjust the clutch cable on a GSXR 1000?

Clutch cable play “a” 10 – 15 mm (0.4 – 0.6 In)

1. Remove the clutch release adjuster cap (4).
2. Loosen the lock-nut (5) and turn out the clutch release adjusting screw (6) two or three rotations.
3. From that position, slowly turn in the clutch release adjusting screw (6) until resistance is felt.

How do you adjust the clutch on a Suzuki Katana 600?

Standard Adjustments

1. Place a ruler at the end of the left handlebar and align it with the clutch lever.
2. Pull the rubber dust cover off of the clutch lever perch and the cable adjuster.
3. Twist the adjuster clockwise to loosen the clutch cable or counterclockwise to tighten the cable.

How fast does a GSXR 750 go?

Top Speed: 189 mph (Est.)

How fast can a GSXR 600 go in first gear?

First gear goes to like 70-80mph anyways (600).

Where is the spring washer on a Suzuki GSX are 1000?

Install the clutch push piece (13), bearing (14) and thrust washer (15) to the countershaft. thrust washer (15) is located between the pressure plate and bearing (14). Install the spring washer seat (16) and spring washer (17) onto the clutch sleeve hub correctly. Apply engine oil to the clutch drive plates.

How to tighten torque clutch on Suzuki GSX are 1000?

Tightening torque clutch sleeve hub nut (a): 95 n·m (9.5 Kgf-m, 68.7 Lbf-ft) Lock the clutch sleeve hub nut with a center punch. Install the clutch push rod (12) into the countershaft.

How do you put oil in a clutch?

Apply engine oil to the clutch drive plates. Insert the clutch drive plates and driven plate one by one into the clutch sleeve hub in the prescribed order. insert the outermost no. 1 Drive plate claws “a” to the other slits “b” of clutch housing as shown in the figure. No. 2 Drive plate (1 pc.) No. 1 Drive plate (8 pcs.)

Tightening torque clutch sleeve hub nut (a): 95 n·m (9.5 Kgf-m, 68.7 Lbf-ft) Lock the clutch sleeve hub nut with a center punch. Install the clutch push rod (12) into the countershaft.

Install the clutch push piece (13), bearing (14) and thrust washer (15) to the countershaft. thrust washer (15) is located between the pressure plate and bearing (14). Install the spring washer seat (16) and spring washer (17) onto the clutch sleeve hub correctly. Apply engine oil to the clutch drive plates.

Apply engine oil to the clutch drive plates. Insert the clutch drive plates and driven plate one by one into the clutch sleeve hub in the prescribed order. insert the outermost no. 1 Drive plate claws “a” to the other slits “b” of clutch housing as shown in the figure. No. 2 Drive plate (1 pc.) No. 1 Drive plate (8 pcs.)