Where is the recirc door actuator on a Chevy truck?
I will do something next time. The recirc door actuator is on the top of the A/C module just above the blower motor on the passenger side of the truck. On mine you can see the door if you open the glove box an look over the top of it.
How to replace HVAC air door actuator silveradosierra.com?
Fixed. Here is how: Then I set the blower knob on #1. Then set the driverside climate slide to the middle (between hot and cold setting). Then reconnected the neg battery terminal. I turned the key on, but didnt crank the engine.
How to replace a / C recirculation door actuator replacement?
1. Move tilt wheel all the way down and set the park brake. 2. Move shifter lever all the way to low gear. Gently pull the instrument bezel towards you all the way around GENTLY until it comes free. I had to kind of press down to get the HOOD to clear the top of the dash panel. You’ll see what I mean. Put the truck back into park.
Where is the HVAC air door actuator located?
The recirculation door actuator is sitting a bit higher to the right, the mode door actuator is accessible from the driver side and the passenger side temperature actuator (my favourite) is on top of the heater box and a real pleasure to replace
I will do something next time. The recirc door actuator is on the top of the A/C module just above the blower motor on the passenger side of the truck. On mine you can see the door if you open the glove box an look over the top of it.
Fixed. Here is how: Then I set the blower knob on #1. Then set the driverside climate slide to the middle (between hot and cold setting). Then reconnected the neg battery terminal. I turned the key on, but didnt crank the engine.
Where is the recirc door control on a GMC CK?
The Recirc door control is found at the center-left of the schematic. It is enabled by Switched +12V when the Blower is on at any speed setting. If the Blower is off, the Recirc door defaults to the fresh air position. The Recirc door actuator is closed when a ground is applied at Pin 4 of the Climate Control PCB.
1. Move tilt wheel all the way down and set the park brake. 2. Move shifter lever all the way to low gear. Gently pull the instrument bezel towards you all the way around GENTLY until it comes free. I had to kind of press down to get the HOOD to clear the top of the dash panel. You’ll see what I mean. Put the truck back into park.