How do I increase the pressure on my log splitter?
How to Adjust the Pump Pressure on a Log Splitter
- Start the engine on your log splitter as you normally would.
- Set the pump lever in the neutral position.
- Twist the screw on the side of the pump clockwise with a flat blade screwdriver to increase pressure, according to the scale printed or embossed on the side.
What oil do I use in a log splitter?
Electric log splitters require hydraulic oil with a 10W (Winter) weight rating. This hydraulic oil type provides lubrication for gears and other mechanical parts during extreme cold and heat, effectively protecting parts from wearing down.
How do you adjust a 2 stage log splitter pump?
How to Adjust a 2-Stage Pump
- Adjust the hydraulic gauge by locating the adjustment screw on the back of the gauge. Use a flathead screwdriver to turn the screw.
- Adjust the pressure switch, located behind the hydraulic gauge, by using a wrench to loosen the lock-nut on the switch, then turning the adjusting screw.
What kind of engine does a log splitter use?
A log splitter uses a gasoline-powered engine connected to a hydraulic pump. The pump compresses fluid under pressure until the pump piston is released with sufficient force to split a wood log. Many log splitters are equipped with an adjustable pump to increase pressure for greater efficiency when necessary.
What happens if hydraulic pump in log splitter fails?
If the hydraulic pump in the log splitter seizes up, replace the pump. The log splitter’s hydraulic control valve directs the hydraulic fluid flow to the hydraulic cylinder to extend and retract the piston and wedge. The hydraulic valve has seals around the actuator rod that can wear out and fail over time.
Why is my maximum log splitter not working?
Therefore, maximum log splitters deal with problems in their power source used to provide the hydraulic pressure. If your electric engine is not starting, then the first step you need to perform is to check your power source. This is the most common problem with log splitters having an electric engine.
Can a 2 stage log splitter be repaired?
Install the gauge between the pump and control valve. The reason repair parts are not available for 2-stage log splitter pumps is that the average hourly repair rates at a hydraulic shop would exceed the replacement cost of a new pump.
How does hydraulic pump work on log splitter?
Most log splitter hydraulic pumps will be two-stage pumps, meaning that they can force the liquid within them to move in two different directions, which allows for the hydraulic arm to be pushed forward to split wood, and also retracted so the machine can be reloaded with a new log.
Why is my log splitter not working properly?
If the pump and lines do not have sufficient fluid in them, the arm will not be able to move with as much force as necessary to split logs efficiently. Ideally, the hydraulic system should be topped up on a regular basis.
How does a 2 stage log splitter work?
A 2-stage log splitter pump has two sections. One section contains a small pump which sends fluid to the system at all times when it is turning, when there is resistance to flow pressure will build until the relief in the control valve opens or the engine bogs down.
How does a log splitter make chopping wood easier?
Chopping wood is now made easier thanks to the help of log splitters. These machines are often built with a hydraulic pump which exerts pressure to push the wood onto a sharpened wedge which causes it to split. Log splitters vary in size depending on the amount of force the pump pressure can apply.