How to install shocks on a Harley Davidson Sportster?
Adjust the jack to raise or lower the swingarm to a position that allows for alignment of the shock eyelet to the shock mount. Apply Threadlocker to the threads of the bolt. Install the bolt and nut. Figure 8. Aligning shock eyelet and installing mounting bolt. Torque the upper and lower shock bolts to 45 to 50 ft/lbs. Figure 9.
Why does my Harley Davidson only run when choked?
Possible intake leak or low speed / idle circuit clogged in carb. Try some Seafoam in tank.. I have not ridden my bike for a while. When I went to start it I pulled out the choke and the bike started fine. Once it had warmed up sufficiently I pushed the choke in and the bike dies.
Which is the best suspension for a Harley Davidson Sportster?
Progressive Suspension offers a wide variety of suspension products for various Harley platforms. Touted as the best shocks on the market today, their 412 Series shocks are typically the first choice for Sportster owners looking for suspension upgrades.
What kind of wrench do you need to mount a Harley Davidson shock?
The bottom mounting bolts require the use of a 3/4″ or 19mm wrench to hold the nut on the backside of the shock. Using your ratchet and socket, loosen the bottom mounting bolt while countering the nut with your wrench.
When does a Harley Davidson run on the choke?
It runs on the choke but not when the choke is pushed in. The choke circuit is a separate feed than the other jets and that’s why it is doing that.
Why does compression drop on a Sportster hammer?
The answer is that in the case of the 1275 at least, absolutely. The reason is that if you’re going to be making breathing improvements, you’ll need new pistons anyway. Making the valves bigger and running more overlap in your cams and running late intake close timing all cause the compression to drop.
How can I soften the curve on my XL1200 Sportster?
If you fail to do this, the motor will lose power, run hot, and there’s a very real chance you’ll scuff your pistons. Softening the curve and pulling back the final timing will be accomplished via either the EFI tuner (07+ models) or an aftermarket ignition module (86-06 models).
Why does my car not run with the choke on?
Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.