How fast will a Kawasaki 4010 go?
The posted speed limit is 25mph. Most folks drive closer to 30mph. According to my GPS speedometer my Mule top speed is 23mph, where the speed governor kicks in.
How many hours is a lot for a Kawasaki mule?
They’d typically put about 15,000 hours on a 550 before it was retired and one of them still lives just fine on a farm with almost 16,500 on it now.
Can you make a Kawasaki Mule pro Fxt faster?
REV-PRO Kawasaki Mule Pro-FXT 800 RPM limiter can be adjusted quickly and easily to reach an even or a higher rpm range than the stock set in order to override factory top end limit.
How many miles does a Kawasaki Mule last?
From what I’ve read, the mules run about 25mph. So, in 1000 Hours, they would have accumulated 25000 miles…. this is approximate averaging. Nobody runs full speed constantly.
How can I make my Kawasaki mule go faster?
An easy way to increase the top speed of your Kawasaki Mule is to make sure that the tires are fully inflated — the flatter your tires are, the slower you’ll go. Disabling the governor is another action you can take to reach faster speeds.
Is there a problem with my Kawasaki MULE 4010?
I took my 2016 Mule 4010 Trans 4×4 in for 500 hour service last week. to open a gate or something. When running at half to full throttle, it was fine, but would surge and run unevenly when at low RPMs. might arise again in the future. Mule owners had returned almost immediately with the same problem. She indicated
What’s the price of a 2009 Kawasaki MULE?
2009 Kawasaki Mule™ 4010 Trans4x4 pictures, prices, information, and specifications. Below is the information on the 2009 Kawasaki Mule™ 4010 Trans4x4.
What kind of tires does a Kawasaki MULE have?
Kawasaki 4010 Trans Mule. Double seat, but can be converted to a single seater with more cargo room. This Mule has had light use, always sheded and rarely driven in winter or 4×4. It is fitted with aluminum rims and 26″ dia. Reptile radial tires as opposed to the 23″ it came with.
What’s the RPM of a Kawasaki Mule Stall?
Then when it settles down, it idles very low and stalls eventually-sometimes it’s almost immediate, sometimes it takes a few seconds, and sometimes it’ll idle at 450-480 RPM (using KDS software) and then just quit.
https://www.youtube.com/watch?v=8iRgGKFf5gw