What do you need to know about the Mitsubishi L200?
Stop Lamp, Anti-Lock Braking System (ABS) Control Unit, Active Stability & Traction Control System (ASTC) Control Unit, High-Mounted Stop Lamp, Key Interlock Actuator (A/T) Front Fog Lamp Relay, Combination Meter, Front Fog Lamp, Spare Connector (for Front Fog Lamp Relay)
Where is the indicator relay on a Mitsubishi L200?
Checked the wiring along the chassis and through into the vehicle under the carpet and all OK. Checked pins from connector forward to the in car fuse board and we are getting short to ground on the pins that supply 12 v + the indicator relay has been replaced for an original Mitsubishi part so have to hope that is a good part?
Are there any hazard lights that have failed?
The hazard lights and indicators have failed. All fuses checked and intact (checked for continuity with multimeter). Checked each indicator bulb holder and every 12 v + lead into the bulb holder is shorting to ground.
Why are the rear lights on my L200 not working?
Disconnected the rear connector for the rear lights and tow bar electrics and the short is still happening on the female pins that should be supplying the 12 v + to the rear lights and tow bar electrics. Checked the wiring along the chassis and through into the vehicle under the carpet and all OK.
What does the red warning light on the Mitsubishi Outlander mean?
If the warning light remains on, discontinue driving and contact a qualified Mitsubishi workshop. The Mitsubishi Outlander red engine overheating warning light indicates that the engine coolant is overheating. Depending on your version of Outlander, the message ENGINE OVERHEATING STOP SAFELY will display. In this instance: 1.
Is the Mitsubishi Pajero headlight warning buzzer working?
Checked all the fuses in the cabin and under the bonnet with a meter and the fused links in the engine bay all ok. Replaced the indicator stalk and the etacs unit on the back of the fuse box with no joy. The hazard lights work ok and always did although the flashing indicator for them does not work neither does the headlight warning buzzer.
What was the fault with my Mitsubishi Pajero?
The fault was when driving the indicators would suddenly stop working along with my Dipped beam, intermittent windscreen wipers, numberplate light, washer jets and light warning buzzer. Also the 4wd dash board indicator would go out. This fault once there would stay until the battery was disconnected for an hour and reconnected.
When does the Mitsubishi Outlander check DPF light go out?
The Mitsubishi Outlander Check DPF System means there’s an excessive amount of particulate matter accumulated inside the diesel particulate filter (DPF). To assist with cleaning of the DPF, drive for around 20 minutes and at a speed of at least 40 km/h (25 mph). The light will go out when the cleaning process has done.