How to repair Mitsubishi L200 airbag code-41 SRS light?
#41 Airbag Code Repair order (“Recheck SRS at each replacement.”) Visually check the wiring harness connection. Replace the harness if it has visible damage. Replace side air bag module (LH). (Before disposal, it must be deployed.) Replace the diagnosis sensor unit. How to disable Mitsubishi L200 airbag module ?
How to reset the SRS light on a Mitsubishi Eclipse?
Wait for the scanner to read the codes and then press “Clear trouble codes” or “Reset” or some similar command to reset the airbag light. Unplug the scanner from the port and start the engine. Verify that the SRS light has turned off. “Mitsubishi Eclipse & Eagle Talon 1995 thru 2005 (Haynes Repair Manual)”; Haynes; 2008
How do I clear a Mitsubishi trouble code?
Ground Data Link Connector terminal # 1. Set the ignition switch to “ON”, the Malfunction Indicator (check engine) Lamp will illuminate for a particular duration and a certain number of times. Clear the trouble codes by disconnecting the vehicle battery negative terminal for 16 seconds or longer
Where to find Mitsubishi check engine light codes?
When retrieving Mitsubishi check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
#41 Airbag Code Repair order (“Recheck SRS at each replacement.”) Visually check the wiring harness connection. Replace the harness if it has visible damage. Replace side air bag module (LH). (Before disposal, it must be deployed.) Replace the diagnosis sensor unit. How to disable Mitsubishi L200 airbag module ?
Wait for the scanner to read the codes and then press “Clear trouble codes” or “Reset” or some similar command to reset the airbag light. Unplug the scanner from the port and start the engine. Verify that the SRS light has turned off. “Mitsubishi Eclipse & Eagle Talon 1995 thru 2005 (Haynes Repair Manual)”; Haynes; 2008
Ground Data Link Connector terminal # 1. Set the ignition switch to “ON”, the Malfunction Indicator (check engine) Lamp will illuminate for a particular duration and a certain number of times. Clear the trouble codes by disconnecting the vehicle battery negative terminal for 16 seconds or longer
When retrieving Mitsubishi check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.