What is the OBDII code for a Mitsubishi Lancer?
2004 Mitsubishi Lancer 2005 Mitsubishi Lancer 2002−2005 Mitsubishi Lancer Factory Service Recall OBDII Code P0421 What does this mean? Cost of diagnosing the P0421 MITSUBISHI code Labor: 1.0 The cost of diagnosing the P0421 MITSUBISHI code is 1.0 hour of labor.
What is the trouble code for a Mitsubishi Raider?
Mitsubishi OBD-II Trouble Codes. Note: See this page for generic OBD-II codes (they start with P0***). Transmission code P0841 Mitsubishi Raider.
What is the diagnostic code for a Mitsubishi check engine?
Refer to our Generic OBD II code list for definitions on all other Mitsubishi diagnostic trouble codes. Manufacturer Specific Codes P1100Induction Control Motor Position Sensor Fault P1101Traction Control Vacuum Solenoid Circuit Fault – Read Our Article On Automotive Circuit TestingFor Help With This Mitsubishi Check Engine Light Code
What to do if your Mitsubishi Lancer has a p0421 code?
Replacing the oxygen (O2) sensors may sometimes fix the code, but in most cases the catalytic convert needs to be replaced to fix the problem. If the P0421 code is combined with other codes, try fixing the other codes first. There is a factory service recall for the following Mitsubishi Models: 2002 Mitsubishi Lancer 2003 Mitsubishi Lancer
What is the engine code for a Mitsubishi Lancer?
Engine code 4A92 Make Year of construction Engine capacity Mitsubishi Lancer 2012 1,600 cc 2016 1,590 cc Mitsubishi ASX 2010 1,600 cc 2011 1,590 cc, 1,600 cc 20 Citroen C4 2015 1,590 cc
What are the trouble codes on a Mitsubishi?
Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds. Reconnect negative battery cable and recheck codes to confirm the repair. Oxygen sensor fault. Airflow sensor fault. Intake air temp sensor fault. Throttle position sensor (TPS) fault. Idle speed control (ISC) motor position sensor fault.
How do you read OBD codes on a Mitsubishi 96?
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.
What are the problems with a Mitsubishi OBD?
Barometric (BARO) pressure sensor fault. Knock sensor fault. MAP sensor faulty. Ignition timing adjustment signal fault. Oxygen (O2) sensor fault. Fuel pump fault. EGR fault. Ignition coil (cylinders #1 & #4) fault.
When to shut off O2 sensor heater circuit?
Some computer systems will shut the O 2 heater circuit off until the codes are cleared. Now, with the ignition switch off, plug the test harness with the light into the vehicle’s O 2 sensor harness connection. The light should remain off until the engine is started. Once the engine is running, the light should come on steady or blink.
How to reset the service engine soon light on my Nissan?
Open the hood and loosen the retaining nut on the negative battery cable clamp using a socket wrench. Slide the cable clamp off of the negative battery terminal. Wait 5 minutes and reconnect the battery cable and then tighten the retaining nut with the socket wrench.