Are there any recalls on the Mitsubishi Challenger?
The safety recall is to fix a fault that could see the powered seats’ reclining lever stick in the operating position after use, allowing current to continue to flow to the seat motor. Mitsubishi Read more I purchased a new 2010 Mitsubishi Challenger LS with a reversing camera and reversing sensors fitted by the dealer.
What causes the Mitsubishi airbag warning light to come on?
Two of the most common problems that trigger Mitsubishi airbag light are defective clock spring or an issue with the passenger weight sensor. Complete a list of the most common problems that trigger Mitsubishi airbag light.
Why does my Mitsubishi Challenger play up at idle?
Low battery voltage can also make an engine like the Challenger’s play up at idle, too. Also, have the throttle-position sensor checked. If this fails, it can leave the computer guessing about what the accelerator pedal is trying to tell it.
Why does the Mitsubishi SRS warning light stay on?
Mitsubishi airbag warning light stays on to notify the driver that the airbags may not deploy if you get in an accident. Airbag or SRS light stays on when the Supplement Restraint System (SRS) detects a malfunction. If the airbags don’t deploy during an accident, you or your passengers may suffer serious injuries.
How to troubleshoot Mitsubishi SRS airbag warning light?
Turn on the ignition and allow the scanner to power on. Select your Mitsubishi model and year. For example, in 2017, Lancer. Select SRS / Airbag Control unit from the main menu. Select Read Fault Codes. Write down all the codes and also make sure they are NOT PRESENT.
When to clear a Mitsubishi airbag fault code?
You should only clear Mitsubishi airbag fault codes if they are in Stored or Past status. Do not clear Current, Active, or Present codes without fixing the problem. Typically even if you try to erase present Mitsubishi airbag codes, they return as soon as you restart the car.
Where is the airbag scanner on a Mitsubishi Lancer?
Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side. Turn on the ignition and allow the scanner to power on. Select your Mitsubishi model and year. For example, in 2017, Lancer. Select SRS / Airbag Control unit from the main menu. Select Read Fault Codes.
When do you reset the airbag warning light?
The vehicle should not be driven until it has been looked at and repaired by a qualified mechanic. Once the repairs have been made, you or your mechanic should reset the airbag light to keep the computer functioning properly and to shut off the SRS warning light.