How can I Fix my LDV immobiliser problem?
Thank you for you precious help. We can supply Ignition key cutting code from your Registration for all the LDV vehicles Maxus/Pilot/Convoy. If you give us the Reg or Vin we can cut and post the key out to you – it if needs a transponder we can pre code this and you can then get it programmed in locally to the Vehicle via local Auto Locksmith.
Why does my imobiliser not stop water getting into it?
They claim to have sent away the faulty box for re-programming and also that the problem was caused by water getting into the unit, and that the imobiliser can’t be bypassed to stop this happening again. Did anyone reply helpfully to the previously posted questions?
What to do when immobiliser light goes out?
Had the same Problem on our 2003 Convoy diesel after taking the battery out and replacing it. Immobiliser light flashing continuously, engine wouldn’t turn over etc. Resolved it by taking out yellow relay below ahtray, turning ignition on, waiting until immobiliser light goes out, then with ignition still on, replace yellow relay.
Is there a way to disable the Immobilizer?
Do you know if there is a method to disable the immobilizer as Mr Cardoc has done or by some other means. Thank you for you precious help. We can supply Ignition key cutting code from your Registration for all the LDV vehicles Maxus/Pilot/Convoy.
Is it possible to bypass the immobiliser without fuel?
PS: If I want to, it’s now possible to crank the engine on the starter without fuel, so perfect for bring the oil pressure up (without starting the engine) after an oil change. OK so I did the surgery yesterday, after a bit of testing with a meter the bypass actually required no additional wiring.
Why is my GFCI tripping in my garage?
Note a common cause of GFCI tripping is the presence of water. Allow electrical cords time to dry and one at a time plug the electrical items until the GFCI trips. Remove this last item from the circuit as it is a safety hazard. If you still have no power to the receptacles it’s time to call a licensed electrician. There you go!
What to do when your garage electrical outlet stops working?
It should be labeled. Reset the breaker by moving the breaker handle to the off position and then back to the on position. If this does not restore power to the receptacles, the problem may be a GFCI type receptacle has tripped and needs to be reset. It can be identified by test and reset buttons on it’s face.
What to do if you bypass the immobiliser and alarm?
After the bypass the immobiliser and alarm remain connected. The drain from the immobiliser and alarm system will therefore remain too. If you have access to a mains power socket close to the car, I recommend the Halfords maintenance charger as a cheap fix.