How do you change the starter on an eclipse?
Place the front end of the Eclipse on two jack stands so you can get under the vehicle. The easiest way to access the starter is raising the front of the vehicle and crawling under it to change the starter. However, you can remove the air cleaner ductwork and reach the starter without getting under the car.
What causes a Mitsubishi Eclipse to not start?
The starter has a lot of moving parts and when just one of those parts wear out, the engine on your Mitsubishi Eclipse will not start. The most common part to wear out is the solenoid and the starter gear. Solenoids are replaceable, but you have to pull the starter out of the car to replace it.
How do you hold a starter in place?
Hold the starter in place and thread the two bolts from the back of the bell housing to secure the starter into place. Tighten the bolts to 30 ft-lbs. Remove the nut from the end of the starter and slide the black wire onto the stud.
How do you remove a starter from a car?
With the ductwork removed, look down between the engine and the radiator to find the starter. Remove the solenoid electrical harness from the starter. Push the locking tab inward and pull the plastic harness off the starter solenoid. Remove the nut that holds the ground wire to the back of the starter with an adjustable wrench.
Place the front end of the Eclipse on two jack stands so you can get under the vehicle. The easiest way to access the starter is raising the front of the vehicle and crawling under it to change the starter. However, you can remove the air cleaner ductwork and reach the starter without getting under the car.
The starter has a lot of moving parts and when just one of those parts wear out, the engine on your Mitsubishi Eclipse will not start. The most common part to wear out is the solenoid and the starter gear. Solenoids are replaceable, but you have to pull the starter out of the car to replace it.
Where is the fuse block on a Mitsubishi Eclipse?
The fuse block in the passenger compartment is located in front of the driver’s seat at the position shown in the illustration. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Hold the starter in place and thread the two bolts from the back of the bell housing to secure the starter into place. Tighten the bolts to 30 ft-lbs. Remove the nut from the end of the starter and slide the black wire onto the stud.