How to remove a snapped crank bolt on a Mitsubishi L200?
Remove the cast tensioner arm from the AC belt route, upper and lower plastic timing covers. Take off the crank angle sensor below the steel ‘chopper’ reluctor plate. Tap off the reluctor plate and mark the timing belt position on all three pulleys with tippex.
How to remove a stubborn crank pulley bolt?
Stubborn Crank Pulley Bolt Removal Procedure – 2 Methods Pick Your Weapon! – YouTube If playback doesn’t begin shortly, try restarting your device.
How to loosen a crankshaft pulley harmonic balancer bolt?
How to loosen a difficult crankshaft pulley harmonic balancer bolt. The first method uses the power of the starter motor, and the second method uses the force of the rolling vehicle. Be sure to disconnect the main coil wire before attempting, because you DO NOT want the car to start when doing this!
How do you remove a crankshaft pulley washer?
<<C>> CRANKSHAFT PULLEY CENTER BOLT/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY REMOVAL 1. Hold the crankshaft pulley with special tools MB990767 and MD998719. 2. Loosen the crankshaft pulley center bolt and remove the crankshaft pulley center bolt, crankshaft pulley washer and crankshaft pulley. INSTALLATION SERVICE POINTS
Which is the most stubborn crankshaft pulley bolt?
Crankshaft pulley bolt is the most stubborn, highly torqued and perhaps the most challenging bolt to remove in a car.
What to do with timing belt on Mitsubishi?
I also suggest soaking the bolt in WD 40, and I STRONGLY recommend a flat-faced socket, dont use those multi-claw rubbish sockets that grip the corners of the bolt, they WILL strip your nut, and this WILL stuff things up. Also, with some cars, the crank bolt is single-use- so recommend getting a new bolt (they stretch).
<> CRANKSHAFT PULLEY CENTER BOLT/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY REMOVAL 1. Hold the crankshaft pulley with special tools MB990767 and MD998719. 2. Loosen the crankshaft pulley center bolt and remove the crankshaft pulley center bolt, crankshaft pulley washer and crankshaft pulley. INSTALLATION SERVICE POINTS
How does a crank shaft lock tool work?
The crank shaft locking tool basically replaces the starter motor and locks the fly, 2 bolts hold it in place. I also suggest soaking the bolt in WD 40, and I STRONGLY recommend a flat-faced socket, dont use those multi-claw rubbish sockets that grip the corners of the bolt, they WILL strip your nut, and this WILL stuff things up.