Why does my tailgate not open on my GMC Sierra?
There are rods and cables on the inside that pull those ears in to release it, it may just be rods on yours and no cables, either way there is too much slack in the setup and you need to remove the slack or something is broken. 20 people found this helpful. ok but how do I get to them to fix the problem? 41 people found this helpful.
What to do if your tailgate won’t open?
The correct solution is to replace the tailgate release handle lock, which requires removing the release rod mechanism. Not a simple fix, but the work around is not too hard and will work as long as you can open the flip up glass lid and you have your trusty heavy duty long handle flat blade screwdriver to pry in the locking latch.
Why is the tailgate on my GMC Envoy SLT not working?
2004 GMC Envoy XUV SLT electronic tailgate will not unlatch. Regulator seems broken. I pushed window fully down by hand, to lowest position, climbed into rear & took off tailgate inside panel exposing multi-pin connector and glass. I made sure glass was all the way down, but tailgate eletronic latches, lay down or swing will not allow gate to open.
How do you remove a latch from a tailgate?
So I had to remove the bolts holding the latch inside in the middle just above the tailgate release lever on the outside. Remove the plastic and metal covers over the release mechanism. Then using a screwdriver, pry the locking latch which prevents the tailgate release rods from releasing the tailgate.
Why is the tailgate on my GMC Yukon not opening?
GMC Yukon Liftgate / Tailgate Won’t Open, How to Open The Lift-gate Manually. – YouTube If playback doesn’t begin shortly, try restarting your device.
What to do if your tailgate is not working?
For the particular problem you have of the electronic latch not working, the bulletin recommends a inspection of the endgate connector C900. Look for the wires to be backed out of the connector or not properly crimped.
Is there a way to open the tailgate on a GMC Envoy?
Clean all the dust under the trim. In addition to that you should open the switch and use contact cleaner to clean out any dust or debris inside there. There is no mechanical way to open the door once the electronic side has malfunctioned without damaging the door. I hope this helps. You can’t post conmments that contain an email address.