Where is the OBD2 connector on a Mitsubishi Space Star?
OBD connector location for Mitsubishi Space Star (1998 – 2005) You will find below several pictures which will help you find your OBD connector in your car. The OBD2 connector is located on the bottom of the center consol, on the right of steering wheel. Go to the OBD2. scanner for MITSUBISHI.
Where is the diagnostic link connector on a Mitsubishi?
Mitsubishi Engines – Please select the connector for your vehicle from the options below. Diagnostic Link Connector No. 21 Locations: Under the drivers side dash panel. Under the drivers side kick panel. Under the passengers side kick panel. Diagnostic Link Connector No.
How do you read OBD codes on a Mitsubishi 96?
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.
How does a Mitsubishi OBD work on a car?
Set the ignition switch to “ON”, the Malfunction Indicator (check engine) Lamp will illuminate for a particular duration and a certain number of times. The Lamp will illuminate for 0.5 seconds, then stay Off for 0.5 seconds, this pattern will repeat until the ignition is turned OFF. The Lamp will illuminate one time for approximately 0.5 second.
OBD connector location for Mitsubishi Space Star (1998 – 2005) You will find below several pictures which will help you find your OBD connector in your car. The OBD2 connector is located on the bottom of the center consol, on the right of steering wheel. Go to the OBD2. scanner for MITSUBISHI.
Why do you need an OBD reader on a Mitsubishi?
A Mitsubishi OBD reader should never miss in your vehicle, since its one of the most essential components. It will help you tune your engine for easy emissions; the code has a backlit display where all troubles are recorded.
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.
Where are the diagnostic connectors on a Mitsubishi?
Locations: Under the drivers side dash panel. Under the drivers side kick panel. Under the passengers side kick panel. Locations: Near the left hand strut tower. Near the right hand strut tower. Locations: Under the drivers side dash panel. In or next to the fusebox under the dash panel.