How to troubleshoot and maintain a lighting control system?

How to troubleshoot and maintain a lighting control system?

Troubleshooting power line control (PLC) control devices in a lighting control system Unfortunately, lighting control systems are rarely “set-’em-and-forget-’em” affairs. There are certain services and tasks required to maintain the system, including its lamps, remote controls, and programming.

Why are the radio and AC control lights not working?

A bit of time (maybe 90 minutes removal, soldering and re-install) and a bit of solder added to a series of resistors on the circuit board and her radio display lights up again. Found the problem. The #4 fuse under the hood, labelled “small lights”.

How to troubleshoot a PLC lamp control system?

There are three major areas you should investigate, and all three should be checked each time, even if you think the problem is obvious: the control, the wiring, and the lamp or lamps being controlled. A common problem with PLC controls is that the device coding for one or more control modules is incorrect.

Why are the back lights on my Radio not working?

The first post above says I had no lighting behind the control buttons on the AC and the radio. The second post states no back lighting on any of the buttons from the VTM-4 switch to the right. As far as finding the fix, but not the problem, it could have possibly been as simple as a bad fuse.

What causes dash lights to fail after installing stereo?

If it is grounding out it would cause the dash lights to fail. Disconnect all orange wires and report back. So i went and dug thru my new hu box and i remember they put a wire diagram in there for me. On mine it says that the Orange/Black isnt used. Ill add a picture to this once it uploads onto photobucket. Biscuits likes this.

What to do if your car stereo is not dim?

If the car audio system does have this setting, try adjusting it to the different dimmer settings. The car stereo may not function properly if the connectors between the receiver and the front panel are not clean. In order to prevent this, do the following: WARNING: There is a risk of personal injury.

What kind of dash lights do I need for a stereo?

OME 885’s, Derped FJ TRD Wheels, Hankook Dynapro’s ATM 265/75/16’s, Retro’s, WeatherTech Liners, Fog Light Mod, Bak Flip F-1, N-Fab Steps, 20% Tint, complete stereo, heated mirrors, Katzkin seats!! I dont know if this helps, but the pioneers do not dim with the dimmer switch.

Why is my car stereo not working properly?

The car stereo may not function properly if the connectors between the receiver and the front panel are not clean. In order to prevent this, do the following: WARNING: There is a risk of personal injury.