Where is the engine located in a Mitsubishi Express?
My Mitsubishi Express 2.4 van is the one with the engine accessed under the passenger seat. That’s pretty much it. Unlike a Ford Territory where you have 56 fuses and numerous relays mounted on several fuseboxes which are not only in the engine bay but squirelled away up behind the govebox, these have 1 shared fusebox.
Why does my Mitsubishi Express not start up?
Distributor models would sometimes do this and yes, it was an electrical problem. The spark plug high tension leads would cause interference with the low voltage crank position sensor leads if they were in close proximity to each other. Car would not start and it was an intermittent problem.
How to remove air tube from Mitsubishi Express?
Remove air tube. Clamps at either end and a bolt arrangement in the middle. Throw the bolt in your spares box once it’s out as it’s just something else that slows you down everytime you pull plugs/degrease engine etc. Once that tube is out its dead easy.
What to do when your crankshaft seal comes off?
Sometimes this key can come off during the process and if so should be located. The clean part of the timing cover is wear the engine oil leak has washed part of the cover off indicating a oil leak. Using a large standard screwdriver or seal puller and pop the seal loose from the timing chain cover or seal housing.
My Mitsubishi Express 2.4 van is the one with the engine accessed under the passenger seat. That’s pretty much it. Unlike a Ford Territory where you have 56 fuses and numerous relays mounted on several fuseboxes which are not only in the engine bay but squirelled away up behind the govebox, these have 1 shared fusebox.
What was the problem with the Mitsubishi Express?
Cost them $1,000’s to replace a timing belt that was perfectly fine then had it fitted incorrectly so the van never ran properly after that. Initial problem was a slipping fan belt. A simple adjustment would’ve been free. May not be a fault. e10 and gas will trip it “on”. Run tank dry/low then top up with ’98. Light ought to gradually fade.
How do you remove a crankshaft pulley washer?
<> CRANKSHAFT PULLEY CENTER BOLT/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY REMOVAL 1. Hold the crankshaft pulley with special tools MB990767 and MD998719. 2. Loosen the crankshaft pulley center bolt and remove the crankshaft pulley center bolt, crankshaft pulley washer and crankshaft pulley. INSTALLATION SERVICE POINTS
Why does my Mitsubishi Express have a plug gap?
Second culprit is plug gap. Set them @ hacksaw blade width. A 1mm gap @ the plug is same electrical resistance as 1cm atmospheric (outside the engine). 10:1 compression ya see. These two variables are related. The larger the plug gap, the more likely the incidence of lead breakdown.