Where is the fuse box in a 2009 Mitsubishi Outlander?
The fuse box is located in the engine compartment (left-side).
Why does the 10A IGN fuse keep blowing out?
When the PGM-FI unit goes bad it can blow the 10A ign fuse, don’t know why or how cause they’re sealed and for added insurance, recommend replacing the regulator as well, but as shadetree mentions above check for corroded grounds or open wires first, before blowing 200 bucks for new parts. bad CDI?
What causes a fuse to blow on an ignition switch?
The good news is that there aren’t too many things in the ignition system itself that can blow your fuse, particularly if the the ignition coil draws its current directly from the battery or alternator via a relay. If that’s the case, then your fault is almost certainly in the ignition switch itself or the wires going to it.
Why does a tripped breaker not blow a fuse?
It will not blow fuses because in order to blow a fuse you have to increase the flow of amps and not restrict it. If there is arching TO GROUND, YES, it will blow fuses because you are increasing the flow of amps or current to ground. If you pull a wire off of a lit light bulb, you will have arching but you will not have a tripped breaker.
What’s the ignition fuse on a Honda 10A?
10A is the ignition fuse. Same thing happened to me couple months ago and I have the same model and year. Kept blowing the ignition fuse, no FI light, no fuel pump, etc. Checked all the wiring, good.
What are the causes of ignition fuses blowing?
What Are the Causes of Ignition Fuses Blowing? Fuses are current overload protection devices, specifically engineered to act as the weak link in an electrical circuit. A fuse keeps a circuit from passing excess current and destroying whatever’s attached to it or melting the wires and starting a fire.
When the PGM-FI unit goes bad it can blow the 10A ign fuse, don’t know why or how cause they’re sealed and for added insurance, recommend replacing the regulator as well, but as shadetree mentions above check for corroded grounds or open wires first, before blowing 200 bucks for new parts. bad CDI?
10A is the ignition fuse. Same thing happened to me couple months ago and I have the same model and year. Kept blowing the ignition fuse, no FI light, no fuel pump, etc. Checked all the wiring, good.
How to diagnose a fuse that keeps blowing?
(EASY) DIAGNOSING A FUSE THAT KEEPS BLOWING, ELECTRICAL (SHORT CIRCUIT, NO START) / ARE YOU SAVED? – YouTube (EASY) DIAGNOSING A FUSE THAT KEEPS BLOWING, ELECTRICAL (SHORT CIRCUIT, NO START) / ARE YOU SAVED?