How do I know if my car has a torque converter?
A rather simple test can determine whether the torque converter is failing. This is how to carry it out: Turn the ignition key and start up the engine. Wait for a few minutes for the engine to warm up, then gently press the accelerator twice and rev up the engine.
Is there a problem with the torque converter?
It could be a problem with the transmission, or the transmission could be perfectly fine and it could be a problem with the torque converter. Torque converter issues on a lot of older transmissions can be diagnosed by carrying out a stall-speed test.
Where do I find the torque converter part number?
Chrysler, Ford, General Motors etc (alphabetically), then by Transmission Type (again alphabetically) and finally by Converter Code (TCS Code). The section below the Converter Part Number (Grey Band) is for information unique to the converter that may assist you in the correct idenification.
How is a torque converter identification catalog organized?
The Catalogue is organized in the following sequence; Manufacturer e.g. Chrysler, Ford, General Motors etc (alphabetically), then by Transmission Type (again alphabetically) and finally by Converter Code (TCS Code).
How long does it take to stall a torque converter?
With one foot on the brake pedal, press the accelerator all the way for 2-3 seconds with the other foot. Be careful not the exceed 5 seconds or the transmission could blow out.The stall speed is the RPM the engine maxes out at.
How to identify a torque converter on a car?
The Yellow Area below that with the Heading in Bold Print is for the “standard” converter identifying data. A photo of the front and rear surfaces of the converter is provided when one is available. Additional data pages are included at the front of each manufacturers section again, to assist in the identification of the correct converter.
How much does it cost to replace a torque converter?
A new replacement torque converter costs between $100 and $400, depending on the vehicle model and converter type. The labor cost to replace the torque converter is between $200 and $1000, depending on the vehicle model, and the workshop will make the work.
What to do if your torque converter is slipping?
If you are experiencing a slipping torque converter and you have replaced the transmission fluid and filter and even done a transmission flush to it, it’s time to remove the transmission from the engine and inspect the seals on the axle into the transmission. Here is a video of how to replace the seals inside a transmission.
When does a torque converter come to a halt?
When your vehicle is slowly coming to a halt, the torque converter only receives a small amount of torque. This means that only a small amount of force is needed on the brake pedal to bring the car to a complete and total stop.