How can I adjust the belt tension on my car?
Any misalignment is usually caused by mounting the generator wrongly. Some cars are fitted with a idler-wheel tensioner, which gives simple and accurate adjustment of the belt tension. Slacken the locknut on the adjuster screw and turn the adjuster until the belt tension is correct.
What should force be for alternator belt adjustment?
Apply a force of 10 kg to the drive belt between crankshaft pully and aircompressor pully, at position directly under and inline with the idler pully. Measure the deflection between the crankshaft pulley and air conditioning compressor pulley. Deflection must be 9 – 10 mm.
How to adjust drive belt tension on MGF alternator?
1. Loosen nut securing drive belt, tensioner pulley. 2. Increase drive belt tension by turning the tension adjusting bolt clockwise. (red arrow) 3. Tighten drive belt tensioner pulley securing nut to 25 Nm. 4. Recheck drive belt tension.
How do you remove a belt from an engine?
Slacken the adjuster and pivot bolts, and push the pump inwards by the cast front plate until the belt is slack enough to ease off. Do not push against any other part of the pump or pipework, or you may damage it. Remove the old belt. If it is the outermost of several belts on the engine, removal is straightforward.
How do you remove a belt from an air conditioner?
Loosen and/or remove the pivot bolts. Then, push the compressor away from the belt. Note: Some compressors use an idler wheel tensioner. In this case, instead of loosening pivot bolts, you’ll loosen the locknut on the idler adjusting screw. Then, turn the adjuster until the belt is loose enough to be removed. Step 2: Remove the belt.
Where is the AC belt located on a car?
Step 1: Locate the AC belt. The AC belt is routed over the AC compressor, which is located at the front of the engine compartment. You may need to raise the vehicle with a jack and support it with jack stands for access. Step 2: Determine which type of belt you have. Determine which type of belt you have.
How does an AC belt tension adjuster work?
The AC defog capability really works well and after constant fogging and sqeegeeing while plowing it sure is nice to be able to see and use my hands for the plow controls. Don’t adjust the belt to tight, you will blow the compressor.
Any misalignment is usually caused by mounting the generator wrongly. Some cars are fitted with a idler-wheel tensioner, which gives simple and accurate adjustment of the belt tension. Slacken the locknut on the adjuster screw and turn the adjuster until the belt tension is correct.