What is the purpose of an engine balance shaft?
[149 Pages Report] A balance shaft is designed to rotate and vibrate in a way that reduces the vibration produced by an engine. Balance shafts are commonly used for engine refinement. Four cylinder engines use a tow shaft, which turns in opposite directions on either side of engine’s crankshaft.
How do you remove a balance shaft from a car?
1. Remove timing belt, downpipe, transfer case and oil pan. 2. Remove alternator, power steering pump, cross member, front and left motor mount to drop the engine low enough. 3. Remove the front case with the left balance shaft attached. This involves pulling the crank shaft sprocket and everything else over the front case. 4.
Which is better balance shaft or EVO transmission?
If you keep your oil level up and maintain the engine properly your balance shafts will be fine. If you are super worried about them, get the EVO balance shafts as they are slightly more aerodynamic.
Can you remove balance shaft on EA888 Gen 2?
As such, it seems almost necessary to remove the balance shafts for a performance build. Surprisingly, the EA888 Gen 2 does seem to support balance shaft removal without much effort.
How do you remove a balance shaft from an oil pump?
The special tool isn’t much help since it slips off when torque is applied. Just tap the teeth with a blunt end to break it loose. Remove the underlying O-ring in the front case groove. Remove the driven gear bolt that secures the oil pump driven gear to the left balance shaft.
1. Remove timing belt, downpipe, transfer case and oil pan. 2. Remove alternator, power steering pump, cross member, front and left motor mount to drop the engine low enough. 3. Remove the front case with the left balance shaft attached. This involves pulling the crank shaft sprocket and everything else over the front case. 4.
If you keep your oil level up and maintain the engine properly your balance shafts will be fine. If you are super worried about them, get the EVO balance shafts as they are slightly more aerodynamic.
The special tool isn’t much help since it slips off when torque is applied. Just tap the teeth with a blunt end to break it loose. Remove the underlying O-ring in the front case groove. Remove the driven gear bolt that secures the oil pump driven gear to the left balance shaft.
How does a balance shaft bearing get installed?
Cover the crank shaft key with a cloth to prevent damage to the oil seal when pulling out the front case. Oil is fed to the right balance shaft from the main oil galley. The bearing is installed with the clinch positioned at 12:00 and the oil hole to the right so that it aligns with the main oil galley opening. 4. Balance shaft bearing install