How do you fix a stuck horn on a Montero?
The metal sheets are hiding behind the airbag. In order to reach them, you have to remove the airbag. Drill the 4 rivets with the 4.5mm auger. Keep the square metal washers and remember to put them back while installing the new rivets in place.
What’s the problem with the horn on the Pajero?
One of the most annoying problems of the Pajero/Montero is the horn which tends to get stuck out of nowhere and wakes up your whole neighborhood. There are 2 main solutions for that issue.
How to fix Pajero / Shogun / Montero problem?
Disconnect the battery negative and positive cables and wait for 60 seconds before continuing the work. In both of the solutions you have to use a Philips screwdriver to unscrew and remove the 3 bolts in the red circles, then, carefully, remove the plastic covers.
What makes the horn stick on the steering wheel?
The horn switch is actually 2 soft sheets of metal which are being “pressed” one against each other every time you push the horn on your steering wheel center. You can see that “switch” in the pictures later in the article. The problems starts while these metal sheets stick one to each other and then it is like you push the horn. PAY ATTENTION!
How to fix Pajero Shogun / Montero stuck horn problem?
In order to do it, you have to cut the green w/black stripe wire, extent it and connect the edges to a switch. In the picture below you can see the edges of the wire and the relevant connector. Connect the battery, verify that the new switch is working, put the plastics back and you are good to go.
What is the horn switch on a Pajero?
The horn switch is actually 2 soft sheets of metal which are being “pressed” one against each other every time you push the horn on your steering wheel center. You can see that “switch” in the pictures later in the article.
The horn switch is actually 2 soft sheets of metal which are being “pressed” one against each other every time you push the horn on your steering wheel center. You can see that “switch” in the pictures later in the article. The problems starts while these metal sheets stick one to each other and then it is like you push the horn. PAY ATTENTION!
Where are the metal sheets for the Horn?
The horn metal sheets located right next to the air bag. Dealing with it might be dangerous and you are doing it on your own responsibility. The writer is not responsible to any damage or injury that might happen during that work or as a result of it.
The metal sheets are hiding behind the airbag. In order to reach them, you have to remove the airbag. Drill the 4 rivets with the 4.5mm auger. Keep the square metal washers and remember to put them back while installing the new rivets in place.
One of the most annoying problems of the Pajero/Montero is the horn which tends to get stuck out of nowhere and wakes up your whole neighborhood. There are 2 main solutions for that issue.
What does it mean when SRS warning light stays on?
SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. It is very unlikely that your airbags are going to deploy randomly, but the concern is that they may not deploy…
What does the SRS light mean on a Mercedes Benz?
What does SRS light mean? SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system.
The horn switch is actually 2 soft sheets of metal which are being “pressed” one against each other every time you push the horn on your steering wheel center. You can see that “switch” in the pictures later in the article.
Is the SRS light on in my car?
Verify that the SRS light has turned off. Katie B. Marsh is a self-published author, article writer, screenwriter, and inventor. After graduating from South Coast College of Court Reporting, she worked as a congressional and freelance court reporter for eight years. She began her writing career in 2005.
Where is the SRS light on a Mitsubishi airbag?
The airbag light will illuminate on the instrument panel as “SRS,” which stands for “Supplemental Restraint System.”. Usually this light only turns on when the vehicle has been in an accident.
Disconnect the battery negative and positive cables and wait for 60 seconds before continuing the work. In both of the solutions you have to use a Philips screwdriver to unscrew and remove the 3 bolts in the red circles, then, carefully, remove the plastic covers.
The horn metal sheets located right next to the air bag. Dealing with it might be dangerous and you are doing it on your own responsibility. The writer is not responsible to any damage or injury that might happen during that work or as a result of it.