Is it OK to replace the top of a strut?
When replacing a strut, it is best to replace the entire unit. Warning: Do not attempt to remove the top nut from the strut. This will make the spring that is compressed into place spring out at a forceful rate. You must have the spring compressed prior to removing this nut.
How do you remove a strut from a Toyota?
Remove the rear side seatback cushion bolt, and remove the cushion by pushing the cushion up, to release it from its back hook, then pulling it out. This will then expose the upper suspension support nuts (i.e., the strut mount) that will be later removed as the last step in the strut removal.
Do you need a compressor to replace struts?
On many cars, the struts/shocks and springs are interrelated or integrated, which means you may need a spring compressor to remove the springs.
What’s the best way to put a strut on a car?
Only use a soft face hammer or dead blow rubber mallot. When installing a strut into the front of a vehicle, it can be tricky to align up the lower control arm ball joint. Use a large pry bar to help lift the strut up against the spring and the ball joint will go into place.
How to install or replace front struts on any vehicle?
How to Install or Replace Front Struts on Any Vehicle! (Full Guide!) – YouTube How to Install or Replace Front Struts on Any Vehicle! (Full Guide!) If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How much does it cost to replace shocks and struts?
Although you can have individual struts replaces, typically you will find that both struts are replaced at the same time. To replace an individual strut, you are looking to pay anywhere from $133 and $439. To replace both the cost will usually be between $239 and $818.
What happens when you replace a tire strut?
You probably notice the difference in how your vehicle rides when you fill your tires with air comply. The difference once you replace the broken struts is far more pronounced. Replacing the struts doesn’t just make your vehicle ride smoother. It also ensures your vehicle and all its parts last longer.
What can I use to loosen the bottom of a strut?
There should be three bolts holding the bottom of the strut in place, which you can loosen with a socket wrench. Up top, the strut extends inside a strut tower with a serious bolt inside the engine compartment. You may need to use an impact wrench with a socket extension to get it loose.