How tall is the stereo in a Mitsubishi Lancer?
A late interior update changed the mechanics of replacing the stereo, but single-DIN (2″ tall) or double-DIN (4″ tall) aftermarket receivers will fit in any of these Lancers.
Can you change the receiver on a Mitsubishi Lancer?
Installing a new receiver in your Lancer isn’t hard, but there are some differences between the 2008-13 models and the 2014-17 cars. You’ll start by opening the glovebox, prying out the trim with a panel tool, and removing one Phillips screw.
How do you change the stereo in a Mitsubishi?
On the later cars, you start by opening the glove box door and removing one exposed Phillips screw on the passenger’s side of the box opening. Pry out the glove box side trim panel to release two clips, then remove the panel and remove the exposed Phillips screw.
Do you need Rockford Fosgate for Mitsubishi Lancer?
You’ll also need to ground the new stereo’s ground wire to the chassis of the vehicle. If your 2008-2013 Lancer does have the Rockford Fosgate system (look for the amp under the driver’s seat), note that the factory system requires a low-level signal from the stereo.
A late interior update changed the mechanics of replacing the stereo, but single-DIN (2″ tall) or double-DIN (4″ tall) aftermarket receivers will fit in any of these Lancers.
Installing a new receiver in your Lancer isn’t hard, but there are some differences between the 2008-13 models and the 2014-17 cars. You’ll start by opening the glovebox, prying out the trim with a panel tool, and removing one Phillips screw.
You’ll also need to ground the new stereo’s ground wire to the chassis of the vehicle. If your 2008-2013 Lancer does have the Rockford Fosgate system (look for the amp under the driver’s seat), note that the factory system requires a low-level signal from the stereo.
On the later cars, you start by opening the glove box door and removing one exposed Phillips screw on the passenger’s side of the box opening. Pry out the glove box side trim panel to release two clips, then remove the panel and remove the exposed Phillips screw.