How do you load a CD player?
Start by pressing the drive’s eject button, which pops out the tray (often called a drink holder in computer jokes). Drop the disc into the tray, label side up. Gently nudge the tray back into the computer. The tray slides back in the rest of the way on its own.
How to clean a CD player in your car?
– YouTube How Do You Clean A CD Player In Your Car? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
How do you remove a CD from a head unit?
A note on the ribbon cable that connects the CD mechanism to the head unit- I did not show it’s removal, but it is fairly simple. Using a small pair of pliers or a flat blade screwdriver, push the plastic clips on either end of the cable TOWARD the side of the harness that the cable plugs into.
What to do if your CD player won’t load?
These units use a rubber roller to load and eject the CD’s. Over time, the roller can become dirty and lose its gripping power. If this is the only issue, it can be cleaned, and I would recommend denatured alcohol. In my case, the roller was dirty, but this was not the only problem.
How to replace the CD player on a Mitsubishi Lancer?
Using a Philips #2 screwdriver remove a 15 mm screw from the trim piece. Using both hands, carefully pull the trim outward section by section. The dashboard and decorative trim are attached to each other, so they will come out as one unit.
What’s the model number for a Mitsubishi Lancer Radio?
The model/part number for the radio unit is: MN141319/DY-3W69U This guide may not apply to models with Rockford Fosgate or navigation systems. No parts specified. The only tool required for this install is a Phillips #2 screwdriver. Of course, you will also need the new replacement radio/CD player unit that you will be installing.
How to remove Black Antenna from Mitsubishi Lancer?
Remove the black antenna connection by simply pulling it out. Remove both the large and small wire harnesses by firmly pressing in and holding the retaining clip. While continuing to hold down the retaining clip, firmly pull the harnesses out. Do not pull harnesses out by the wires, as you may damage or break the wires.