How do you change the transmission fluid in a Mitsubishi?
Clean the transmission pan using a small amount of degreaser on your shop rag. Any old fluid remaining in the pan could contaminate the new fluid, so it is important to wipe the pan thoroughly. Replace the transmission pan by screwing the bolts back into place using your socket wrench.
Are there any problems with the Mitsubishi Lancer transmission?
Regarding transmission concerns, the worst model years of the Lancer are the 2006, 2008, and 2011 years, with the most-reported problem being the radiator leaking in the 2006 year. In the least-reliable 2008 model, owners complain of the transmission overheating and the transmission slipping.
How to change transmission fluid and filter Mobil?
The filter contains fluid, so keep the drain pan underneath. Step 5: Install the new transmission filter, making sure that its O-ring seats in the appropriate orifice. Step 6: Attach the new gasket to the pan with oil-soluble grease –not gasket sealer or adhesive.
How do you remove a filter from a transmission?
Pull the drain plate from the transmission. Look inside the transmission and locate the filter. Connect the filter removal tool to the filter. Twist the filter loose and remove. Insert the new filter into place and tighten. Place the drain plate to the transmission. Replace the securing bolts to the drain plate.
Where is the transmission pan located in a Mitsubishi?
The transmission pan on a Mitsubishi is located at the underside of your transmission, closer to the driver’s side front of the car. Uncap the drain plug at the center of the transmission pan. Beware that hot fluid will pour out, so stay physically clear of the transmission pan as soon as the cap is released.
How often should you change your transmission fluid?
Cars that typically drive less busy roads in suburban areas may be stretched to every 30,000 miles for a routine transmission fluid change. Either way, if you are familiar with working on cars and have the necessary tools, changing your own transmission fluid can be done in an hour’s time or less.
What to do when transmission fluid stops draining?
Your drip pan on the ground is intended to catch the draining fluid. Use your 17mm socket wrench to unscrew the other bolts from your transmission pan after the fluid seems to have stopped dripping from the transmission pan.
Clean the transmission pan using a small amount of degreaser on your shop rag. Any old fluid remaining in the pan could contaminate the new fluid, so it is important to wipe the pan thoroughly. Replace the transmission pan by screwing the bolts back into place using your socket wrench.
Where do you put the transmission fluid in a Lancer?
Any auto parts store will have the transmission fluid, seal and solvent that you’ll need. Raise the front end of the Lancer off the ground using the jack. Rest the front end on jack stands. Locate the transmission fluid drain plate on the bottom of the transmission. Place the drain pan under the transmission plate.
How can I check the transmission fluid level?
Move the shifter into Reverse, Neutral, Drive, Low gears stopping for a few seconds on each gear. Move the shifter back in Park and allow the engine to idle. Pull the hood release under the dashboard and open the hood. Locate the transmission dipstick and pull it up. Wipe the dipstick clean with a lint free cloth.
The transmission pan on a Mitsubishi is located at the underside of your transmission, closer to the driver’s side front of the car. Uncap the drain plug at the center of the transmission pan. Beware that hot fluid will pour out, so stay physically clear of the transmission pan as soon as the cap is released.