How big of an oil drain plug do I Need?
Oil Drain Plug OE Gasket Fiber Gasket Drain Plug Torque Foot lbs Drain Plug Torque Inch lbs Thread Size BUICK Commercial Chassis (Cont’d) 1996 5.7L 350cid English Thread DP-052 G-016 15 180 1/2-20 1996 5.7L 350cid Metric Thread DP-079 15 180 M12-1.75 Electra 1985-90 3.8L 231cid DP-052 G-016 30 360 1/2-20
How do you change the oil in a Mini Cooper?
Find the new copper crush washer in your Oil Change Kit, and replace it on the oil drain plug. Once the oil has completely drained, climb back under the car, and replace the oil drain plug.
Where is the drain plug on a Mitsubishi Outlander?
Do not be tempted to undo the transfer case drain plug which is near the back of the engine in the middle. The transfer case drain plug on my vehicle uses a hex key which makes it easy to distinguish from the transmission drain plug. The transmission fluid drain plug is located on the passenger side near the front wheel and is a simple bolt head.
How to remove drain plug from Mercedes Benz?
To remove the plug use the 13mm wrench or socket and turn the bolt counterclockwise. Please note that it is easy to confuse the direction that you need to turn the drain plug.
Where is the oil drain plug on a Mini Cooper?
Find the 8mm Hex oil drain plug on the engine’s oil pan at the bottom of the engine. Carefully remove the drain plug and make sure you have your oil drain pan ready below the drain because the oil will flow out fast and hot. Rubber gloves are recommended to prevent a possible burn from the hot oil.
Simply remove it from the housing. Once all of the oil has drained from the engine’s oil pan, take the drain plug and new copper washer (comes with oil filter kit) and screw it back into the oil drain. Hand tighten it first, then tighten to 25 Nm (18 ft./lbs). If the old copper washer is stuck to the oil pan, use a screwdriver to pry it off.
Oil Drain Plug OE Gasket Fiber Gasket Drain Plug Torque Foot lbs Drain Plug Torque Inch lbs Thread Size BUICK Commercial Chassis (Cont’d) 1996 5.7L 350cid English Thread DP-052 G-016 15 180 1/2-20 1996 5.7L 350cid Metric Thread DP-079 15 180 M12-1.75 Electra 1985-90 3.8L 231cid DP-052 G-016 30 360 1/2-20
What should torque wrench settings be on Mini Cooper?
Do those nuts and bolts up properly, or a wheel might fall off… if you’ve been trying to find correct torque wrench settings for your Mini here they are for just about everything that matters. Drive shaft nut (front hub, drum brakes). Continue tightening until next split pin slot aligns. Do not slacken off until the next slot aligns!