What kind of wiring does a Silverado Sierra use?
SilverSurfer the wire colors that you gave me did not match the truck wiring nor did the wiring diagram I have, both were different . the VSS wiring was a GRN/BLK and a PPL/Blk. ann OHM check of the wiring from the VSS plugs to the PCM showed 0 OHMs. The problem was in the lower connector.
When did the GMC Sierra truck come out?
The GMC Sierra is the fifth-most popular truck in the United States, with more than 230,000 trucks sold in 2019. General Motors introduced the GMC Sierra and its twin, the Chevrolet Silverado, in 1998.
Is there a problem with the ignition on my GMC Sierra?
This problem occurs in minivans, cars and SUVs as well. There has been more reports of ignition Anti Theft defects and the security light flashing in more cars and trucks. This is one of the easy fixes for the common ignition starting problem, but GM needs to recall this issue and fix it for us.
What does the sensor do on a GMC Sierra?
A sensor tells the security system whether the key is in the ignition or not. This is a common feature in the GMC, Pontiac, Oldsmobile, Saturn, Chevrolet and other past and present GM brand vehicles. The wire, which is connected to that sensor, comes loose or corroded and needs to be secured or cleaned.
What kind of wiring does a 2005 GMC Sierra 1500 have?
Automotive wiring in a 2005 GMC Sierra 1500 vehicles are becoming increasing more difficult to identify due to the installation of more advanced factory oem electronics.
Where is the turn wire on a Chevy Silverado?
Locate the Dark Blue wireand activate the passenger side turn indicator. Probe the Dark Blue wireto verify that flashing turn indicator power is present. Deactivate the turn indicator and depress the brake to make sure you have not located the rear turn wire. Label that wire as front, PASSENGER SIDE TURN.
What’s the signal harness on a Chevy Silverado?
Signal®mirror harness (short for driver side and long for passenger side). Slide the end with no connector through the routing passage (from the inside of the mirror housing) and through the hole in the rubber insulation. Attach the rubber insulation to the mirror mounting frame.