What are the trouble codes for General Motors?
Loop Resistance High DTC B1016 Passenger Deployment Loop Resistance Low DTC B1017 Passenger Deployment Loop Open DTC B1018 Passenger Deployment Loop Short to GND DTC B1019 Passenger Deploy.
What are the OBD codes for GM cars?
Note: See this page for generic OBD codes (they start with P0XXX). Go back to the GM OBD Codes main page. DTC B1015 Passenger Deploy. Loop Resistance High DTC B1019 Passenger Deploy.
What was the problem with my GMC Sierra 1500?
Did have one cracked vacume line from the throttle body to the purge solenoid, also replaced. Seems to have plenty of vacume through out the system. Removed and inspected the egr valve, no excessive carbon build up and appears to be working properly, good vacume going into the solenoid, replaced the solenoid just for good measure.
What does the fuel smell like in a GMC Sierra 1500?
If so pull the air filter off and sniff the throttle body for a fuel smell. If the diaphragm has ruptured it will literally be like putting a hose with fuel into the intake and running it full.
Can a 1999 Chevy c1500 / k1500 start?
Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so. 205 people found this helpful.
Why is code 1 not clear on my Chevy truck?
The codes will not clear if the 20-amp T-casefuse is not removed for at least 30 seconds. Code 1 will continue to occur until the ignition switch is cycled from “RUN” to “OFF” five times. Ask Your Own Chevy Question Customerreply replied 12 years ago i tried what you suggested, it didn’t work.
Can a Chevy C / K 1500 run without fuel?
Also I haven’t fully checked the Spark, but the Truck run’s fine when you spray Starting fluid into the Throttle body. Any suggestions on why the truck isn’t accepting the fuel, it cranks fine, just wont run without starting fluid. these trucks have to have between 55-65psi of fuel to run.
Where is the RPO code on a GMC?
Identify your GMC or Chevrolet rear end gear ratio by the RPO Codes, usually located on the placard labeled “Service Parts Identification” inside the drivers door panel or glove box.