What does the error code p1409 stand for?
Error Code P1409 is defined as EGR Vacuum Regulator Solenoid Circuit Malfunction. This error code refers to a test to check the electrical function of the EGRVR (Exhaust Gas Recirculation Vacuum Regulator) solenoid.
How much does it cost to get a p1409 Ford code?
The cost to diagnose the P1409 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
Why does my check engine light say p1409?
Aside from the activation of the Check Engine light and the registry of the Error Code P1409 into the system, vehicles affected with this error code usually experiences pinging problem, which makes sense for vehicles with EGR valve issue. Other symptoms typically include: Many factors may cause this error code to arise.
What was the cause of the Ford p1409 accident?
P1409 FORD Possible Causes 1 Faulty Exhaust Gas Recirculation Vacuum Regulator (EGRVR) solenoid 2 EGR Vacuum Regulator Solenoid harness is open or shorted 3 EGR Vacuum Regulator Solenoid circuit poor electrical connection 4 Damaged Powertrain Control Module (PCM)
What does emission code p1409 mean?
P1409 Meaning This test checks the electrical function of the Exhaust Gas Recirculation Vacuum Regulator (EGR VR) solenoid. The test fails when the EGR VR circuit voltage is either too high or too low when compared to the expected voltage range. The EGR system must be enabled for the test to be completed.
What is p1409 OBD2 code?
P1409 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code. It is considered generic because it applies to all makes and models of vehicles, although specific repair steps may be different depending on your car model.
What does the code p1408 mean?
Error Code P1408 is described as EGR (Exhaust Gas Recirculation) out of self-test range. This means the EGR valves are not functioning properly, causing it to send readings that are outside the set range. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes.
What does a diagnostic code P1401?
P1401 Diagnostic Module – Tank leakage , (DMTL) System Malfunction. With this code condition the DMTL air pump motor current draw is higher or lower than expected, Water has been known to enter into this pump where the elbow connection has to be removed and inspected for. Hyundai has produced a TSB for this condition TSB #00-30-002.